Reverse Mode
This key will allow you to observe the reverse frequency of the repeater. While pressing RVRS, the standard pair frequency will be displayed. For a list of the standard pair frequencies, refer to the table "Reverse List" in the Appendix. If the frequency that you have chosen does not have an offset frequency, the display will indicate ERROR and NO REVERSE. This feature does not work in the Weather Search mode.
Channel Step Selection
You can set channel steps, 5 kHz - 100 kHz or Auto, in Conventional mode or Chain search mode. The default receive mode should be the proper mode setting in almost all cases. You may wish to set some VHF channels for NFM mode, depending on any adjacent channel interference problems. WFM is typically only used for broadcast frequencies, such as TV audio or FM radio.
See STEPS in "Menu Description" for details.
Mute On/Off
To manually turn ON the Mute function, press and hold MUTE until MUTE ON is displayed. You will not hear any audio. This feature does not function in the WX Alert mode, because the audio is already muted. To turn it OFF, press and hold MUTE again.
Receiving Mode Selection
You can also set the receiving mode, AM or FM etc., in Conventional mode or Chain Search mode.
See MODE in "Menu Description" for details.
Frequency and Channel Tuning with the VFO Control
The VFO knob can be used for stepping frequencies or through memory channels (for Conventional channels or Talkgroup ID Scan Lists).
To switch the setting for the VFO control, press the VFO. This will change modes from Channel to Frequency or Frequency to Channel.
1.In Conventional mode, when the setting for the VFO is channel, rotate the VFO to move up (to step up through channels) or down (to step down through channels). If you are in Trunk Manual mode, you will step through Scan List memory locations.
2.In Chain Search mode, when the setting for the VFO is frequency, rotate the VFO to move up to step up through frequencies sequentially or to down to step down through frequencies. To change the step, you will need to go into the Chain Search menu and adjust the step for the desired memory location.
☞Remember! When you set Additional Features through the menu screen, you can also use ▲ or ▼ instead of rotating the VFO.
Also instead of pressing E, you can press the VFO control.
77