Frequency Skip
If a particular frequency continues to interrupt search scanning, it is possible to set your scanner to skip the frequency.
To skip over a frequency, press L/O when stopping at the frequency you want to skip or when in Search Hold mode.
Note: • You can program up to 200 skip frequencies. The 201st skip frequency entered causes the first skipped frequency to unlock.
• If all frequencies in the search range are set to skip, a beep sounds and it moves to Search Hold mode.
To resume searching.
1)Cancel the Frequency Skip set.
–––OR
2)Reset the Search Frequency range.
To cancel all skipped frequencies, press and hold L/O for 2 seconds in Search Hold mode.
Storing Search Frequencies
You can quickly store any frequency you find during Search.
1.During Search, press ▲/HOLD or LIMIT/▼ to store or when the scanner stops on the frequency you want to store.
2.Press TRNFR to store the frequency in the channel you selected. The smallest empty channel number flashes on the display. If necessary, you can also change the channel by scrolling the VFO or using ▲ or ▼.
3.Press E.
SRCH 12.5k
1240.0000 NFM
Range 1
C004 0000.0000
Note: • If the frequency you want to store exists already, WARNING appears on the display and you will hear a beep. (See “Duplicate Frequency Alert” on page 27.)
•After storing the frequency, it moves to the Search Hold mode.
•In case there is not a free channel, the frequency you want to store will automatically be stored in the previous channel before you entered into Chain Search mode.
4.Repeat steps 1, 2 and 3 after starting the search for all the Search Frequencies you want to store.
38