| Installing Standalone Units | |
|
|
|
Step | Action |
|
|
|
|
5 | Take the enclosure cover and connect the power cable to the |
|
| backplane connector. Be sure to align the keyed pin on the cable to |
|
| the connector. |
|
|
|
|
6 | Align the enclosure cover and bottom, and press the two gently |
|
| together. |
|
| This requires alignment of the backplane and the locking tabs. Be |
|
| sure that the cables are not pinched between the enclosure and metal |
|
| parts. When all elements are correctly aligned, the locking tabs snap |
|
| into place. |
|
|
|
|
7 | Tighten the locknut and washer on the rear panel. |
|
|
|
|
8 | Insert the four locking clips into the slots. |
|
|
|
|
9 | Reinstall the door by gently pressing the hinge parts together. |
|
| After the card has been properly installed, reconnect the cables and |
|
| turn on the unit. |
|
|
|
|
|
|
|
Installation |