DSU DIM Installation
Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to take adequate measures to correct the interference.
This product was verified under test conditions that include use of shielded DTE cable(s). Leased line cables with 1.5 turns through a ferrite cylinder were also used. Use of different cables will invalidate verification and increase the risk of causing interference to radio and TV reception.
You can obtain the proper cables from VanguardMS.
If this equipment causes interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorienting the receiving antenna
•Relocating the equipment with respect to the receiver
•Moving the equipment away from the receiver
•Plugging the equipment into a different outlet so that the equipment and receiver are on different circuits
If necessary, you should consult the dealer or an experienced radio/television technician for additional circuits.
You may find the following booklet prepared by the FCC helpful: How to Identify and Resolve
If Problems Arise If any of your equipment is not operating correctly, immediately remove it from the Installing the DSU telephone line before it harms your network. If the telephone company notes the
DIMproblem, they may temporarily disconnect your service. They will notify you in advance of the disconnection, when possible. If advance is not feasible, you will be notified as soon as possible. When you are notified, you will be given the chance to correct the problem and be informed of your right to file a complaint with the FCC.
If your 6500 IFX needs repairs, they should be performed by VanguardMS or an authorized representative of VanguardMS. For information, contact the VanguardMS Customer Support Center at
Installation |