2.1.1 Installing and Starting the Maintenance Console
*1
*2
*3
*4
When not using a DHCP server to obtain a DNS server IP address automatically:
a.Select Manual for the DNS Server Address Method setting.
b.In the Manual Preferred DNS Server IP Address box, type the IP address of the preferred DNS server.
c.In the Manual Alternate DNS Server IP Address box, type the IP address of the alternate DNS server.
d.Click Apply.
The system menu appears. You may now begin programming the PBX.
Notice
•Do not change the IP addresses of the IPCMPR/IPCEMPR and DSP cards once IP telephones are registered to the PBX using these IP addresses.
The IP telephones will not operate properly if these IP addresses are changed.
•A DHCP server must be able to use a "client identifier" option specified by RFC 2131.
•The PBX will not start properly if the IP addresses cannot be assigned automatically by the DHCP server when DHCP Client is set to Enable. In this case, you need to consult your network administrator because the DHCP server on your network may not be running or a network failure may have occurred. If the DHCP server cannot be available, change the DHCP Client setting to Disable and set fixed IP addresses, then restart the PBX.
To change the DHCP Client setting, connect the PC with an
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Valid subnet mask address range:
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Programming Manual for Virtual SIP Trunk Card
15