Panasonic PPP Point to Point Protocol Type Connection, Direct connection to the WJ-NT104

■PPP (Point to Point Protocol) Type Connection

●Access from a Client PC to the WJ-NT104

•Direct connection to the WJ-NT104

In this configuration, a client PC accesses the WJ-NT104 via a public line using PPP (Point to Point Protocol). With PPP MODE in the NETWORK SETUP dialog box set to P to P ACCESS, the WJ-NT104 can be accessed by a PC running Windows95, for example.

		RS-232C
RS-232C		cable
cable
Camera (max. 4)		Modem/TA
Modem/TA
WJ-NT104		PC
	Public lines	(Windows 95 etc.)

Note: Connection between the WJ-NT104 (DB 9-pin) and Modem/TA (DB 9-pin or DB 25-pin) are shown figure below.

DB9	DB25	DB9	DB9
1	8	1	1
2	3	2	2
3	2	3	3
4	20	4	4
5	7	5	5
6	6	6	6
7	4	7	7
8	5	8	8
9	22	9	9

• Connection via a dial-up server (or a router)

Set an WJ-NT104 telephone number and IP address in the dial-up server (or ISDN, POTS router) in advance. This configu- ration enables the dial-up server to access the WJ-NT104 using PPP (Point to Point Protocol) when a PC specifies the set address. With PPP MODE in the NETWORK SETUP dialog box set to NETWORK ACCESS, the WJ-NT104 can be accessed by a PC running Windows95, for example.

Camera (max. 4)

WJ-NT104

RS-232C	RS-232C		LAN
cable		cable
Modem/TA	Modem/TA	Dial-up server/
CSU/DSU	CSU/DSU	router etc.
	Public lines

PC (Windows95 etc.)

●Access from the WJ-NT104 to a Client PC

Set the telephone number, user name, password, etc. of the client PC in the WJ-NT104.

In this configuration, the WJ-NT104 calls the registered destination and accesses it using PPP (Point to Point Protocol) when an alarm input is received.

RS-232C	RS-232C	LAN
	cable
WJ-NT104 cable
Camera (max. 4)	Modem/TA
Modem/TA

PC (WindowsNT etc.)

Public lines

11