Panasonic WJ-NT104 operating instructions Utility Software, Network Setup, Connection

UTILITY SOFTWARE

■Network Setup

For the network setup, you need to set the IP address using the Utility Software provided and connect the WJ- NT104 to a PC via the RS-232C port.

●Connection

The COM1 port of the RS-232C interface is used for setting the IP address. Your PC should be IBM-PC compatible, have Windows95, Windows98 or Windows NT4.0 installed, and have an RS-232C port.

Before installing the Utility Software provided, read the Readme.txt file on Utility Software disc.

qConnect the RS-232C port on the front of the WJ-NT104 and the RS-232C port of the PC with an RS-232C cable.

wSet bits #7 and #9 of the MODE selector to ON position (leave the others on OFF), and then press the RESET button on the front of the WJ-NT104.

eClick the Start button, point to Programs and then WJ- NT104 Utilities, then click Network Configuration.

rTo set the IP address: Enter the IP address into the [IP ADDRESS] fields of the dialog box, then click the [SET] button. If the IP address has been set properly, the response command REI and the IP address enter- ed (in hexadecimal, 8-bit notation, e.g., REI:COA8000A for IP address 192.168.0.10) should appear in the WJ- NT104 RESPONSE field. If a wrong number is shown, click the [SET] button again.

tTo set the netmask: Enter a set value into the [NET- MASK] fields of the dialog box, then click the [SET] button. If the netmask has been set properly, the response command REM and the set value entered (in hexadecimal, 8-bit notation, e.g., REM:FFFFFF00 for the set value 255.255.255.0) should appear in the WJ- NT104 RESPONSE field. If a wrong number is shown, click the [SET] button again.

yTo set the default gateway: Enter a set value into the [DEFAULT GATEWAY] fields of the dialog box, then click the [SET] button. If the default gateway has been set properly, the response command REG and the set value entered (in hexadecimal, 8-bit notation, e.g., REG:COA80001 for the set value 192.168.0.1) should appear in the WJ-NT104 RESPONSE field. If a wrong number is shown, click the [SET] button again.

uComplete the setup by clicking the [EXIT] button.

iReturn all switches on the MODE selector to OFF posi- tion and then press the RESET button on the front of the WJ-NT104.

This completes setup and return to the normal applica- tion mode.

RS-232C cable

WJ-NT104

PC

1	1
2	2
3	3
4	4
5	5
6	6
7	7
8	8
Frame	Frame
	Shield

9-pin D-sub connector	9-pin D-sub connector
(female)	(female)

54