Panasonic WJ-NT104 operating instructions Contents Upload

CONTENTS UPLOAD

Contents can be uploaded by means of an FTP (File Transfer Protocol). The following describes how to upload contents produced by using a PC.

■Uploading a File

Upload contents produced by using a PC by the follow- ing procedures.

qClick the [Start] button, point to Programs, and then click MS-DOS Prompt to open the MS-DOS window.

wEnter an FTP command in the MS-DOS window and start the FTP. Then enter the IP address of the WJ- NT104.

C:\CONTENTS>FTP 192.168.0.10

eIn response to the input request for a user account, log in the user at the administrator level (Level 1).

User (192.168.0.10 : (none)) : admin

rEnter a password. Password:

tAfter finishing the log-in operation, enter “bin” to select a binary transmission mode.

ftp>bin

yEnter a put command to upload the file. ftp>put upload.html

uAfter finishing the transmission, enter “quit” to exit from the FTP.

ftp>quit

Notes

To transmit more than one file at a time, enter “prompt” to release the interactive mode, and follow “mput” of the input command with a wild card symbol (for exam- ple, “*”).

ftp>prompt Interactive mode off ftp>mput *.html

■Content Storage Memory

•Content files such as HTML that have been uploaded by means of the FTP are stored in the flash ROM of the WJ-NT104. Hence, they are protected from erasure when the power switch is turned off. However, they are returned to an initial state during version-up operation or if reset after turning on the Mode Setup Switch “2” of the WJ-NT104. Be sure to back up the files before attempting to conduct such operations.

•No directories can be prepared in the content memory interior.

•Reading of the contents file name is case-sensitive.

Storing capacity: Approx. 1.5 Mbytes in total

Number. of storable files : Max. 650

*The above figures are subject to change, depend- ing on file sizes and memory usage.

72