Panasonic UB-5315 installation manual Replacing the Thermal Transfer Film

Page 16

Replacing the Thermal Transfer Film

The unit is capable of producing about 15 more copies when the Contrast/Remaining Film Indicator begins to flash. The unit has run out of thermal transfer film and can no longer make copies when the Multi-Copy/Error Indicator flashes “ ”. Separately available replacement film (UG-6001) may be purchased from the dealer where you purchased the unit. Thermal transfer film is replaced as follows.

Notes on Replacing Thermal Transfer Film

•Only use the designated product (UG-6001) from Panasonic as the replacement film. (Note that using another type of replacement film may result in degraded printing quality or damage to the unit.)

•Thermal transfer film is disposable. Dispose of used thermal transfer film as “burnable” or “non- recyclable” rubbish.

•A negative of the copied image will remain on the thermal transfer film. To protect the security of your information, we recommend cutting up the used thermal transfer film with scissors or shredder before disposing of it.

1

2

Push down the printer open lever to open the printer door, and remove the used film.

Refer to steps 3 and 4 in the section of “Installing the Thermal Transfer Film” on pages 10, 11.

Notes

•If “ ” is still flashing after closing the printer door, make sure that the thermal transfer film has been installed properly and tightened.

•The printer door should be closed to make copies properly. Confirm both latches are locked.

16

Image 16

Contents UB-5815 Electronic BoardThank you for purchasing the Panasonic Electronic Board AccessoriesRecord these items for future reference Table of Contents How to replace the fuse For Your SafetySafety Information Precautions Precautions CD-ROMReplacing Part Names and Functions Part Names and Functions Control panel Panel Name DescriptionInstalling the Thermal Transfer Film Set the power switch to onPush down the printer open lever and open the printer door Insert the blue shaft into the front left holeInstalling the Thermal Transfer Film Loading Copy Paper Pull the paper cover forward as shown in the left figureLoading Copy Paper Close the paper cover until a click is heardMaking Copies Press the Copy KeyMaking Copies Copy types and procedures Copy Type Procedure Replacing the Thermal Transfer Film Paper Jams Remove the jammed paperInstall the thermal transfer film Paper JamsTurn the power on Close the paper coverLoosen the height adjustment handles Screen Height AdjustmentHang the screen in the desired slots of the slide plates Screen Height Adjustment Tighten the height adjustment handlesContents of CD-ROM Connecting the unit to a computerComputer Interfacing System requirementsInstalling the driver and software Installing the USB and Printer driver WindowsComputer Interfacing Check button and click the Next buttonWindows Me Special Note for Windows 98/Me Power on your computer and start Windows Although Digital Signature NotWindows XP UB5 USB Printer A4/Letter* driverClick the Install Panasonic-DMS Software button Installing Panasonic-DMS software and Twain driverClick on the desired language Removing the driver and software ScanningRemoving Panasonic-DMS software and Twain driver Acquire Image..., or clickComputer Interfacing Panaboard Operation Panel Printing Status BoxAbout Button Close ButtonDaily Care and Maintenance Cleaning the screen and the unitCleaning the printer head, platen roller and pick-up roller Caring for the eraserDaily Care and Maintenance Troubleshooting Symptom Care and Remedy SeeTroubleshooting Meanings of error codes Indication Cause Remedy SeeModel No UB-5315 UB-5815 SpecificationsOption and Separately available