Panasonic UB-5315 installation manual Paper Jams, Install the thermal transfer film

Page 18

Paper Jams

4	Install the thermal transfer film.
	Install the thermal transfer film.
	• Refer to steps 3 and 4 in the section of “Installing the
	Thermal Transfer Film” on pages 10, 11.
	• “ ” flashing on the Multi-Copy/Error Indicator will go
	out.

Notes

•If “ ” is still flashing after closing the printer door, make sure that the thermal transfer film has been installed properly and tightened.

•The printer door should be closed to make copies properly. Confirm both latches are locked.

If the flashing “ ” does not go out after the foregoing procedure has been performed; this may indicate that the paper feeder is not functioning properly.

Reload the copy paper by following the steps given below.

1

ON

OFF

2

Turn the power off.

Open the paper cover and remove all the copy paper remaining inside the unit’s paper cover.

Note

•The copy paper will slightly resist being removed, but may be pulled out without problems.

18

Image 18

Contents UB-5815 Electronic BoardAccessories Thank you for purchasing the Panasonic Electronic BoardRecord these items for future reference Table of Contents For Your Safety How to replace the fuseSafety Information Precautions Precautions CD-ROMReplacing Part Names and Functions Part Names and Functions Control panel Panel Name DescriptionPush down the printer open lever and open the printer door Installing the Thermal Transfer FilmSet the power switch to on Insert the blue shaft into the front left holeInstalling the Thermal Transfer Film Loading Copy Paper Pull the paper cover forward as shown in the left figureLoading Copy Paper Close the paper cover until a click is heardMaking Copies Press the Copy KeyMaking Copies Copy types and procedures Copy Type Procedure Replacing the Thermal Transfer Film Paper Jams Remove the jammed paperInstall the thermal transfer film Paper JamsTurn the power on Close the paper coverScreen Height Adjustment Loosen the height adjustment handlesHang the screen in the desired slots of the slide plates Screen Height Adjustment Tighten the height adjustment handlesComputer Interfacing Contents of CD-ROMConnecting the unit to a computer System requirementsComputer Interfacing Installing the driver and softwareInstalling the USB and Printer driver Windows Check button and click the Next buttonWindows Me Special Note for Windows 98/Me Power on your computer and start Windows Although Digital Signature NotWindows XP UB5 USB Printer A4/Letter* driverInstalling Panasonic-DMS software and Twain driver Click the Install Panasonic-DMS Software buttonClick on the desired language Removing Panasonic-DMS software and Twain driver Removing the driver and softwareScanning Acquire Image..., or clickComputer Interfacing Panaboard Operation Panel About Button PrintingStatus Box Close ButtonCleaning the printer head, platen roller and pick-up roller Daily Care and MaintenanceCleaning the screen and the unit Caring for the eraserDaily Care and Maintenance Troubleshooting Symptom Care and Remedy SeeTroubleshooting Meanings of error codes Indication Cause Remedy SeeSpecifications Model No UB-5315 UB-5815Option and Separately available