Panasonic CF-35 Add-ons/Peripherals, Using a CD-ROM Drive, Installing/Removing the Unit

Page 22

Add-ons/Peripherals

Devices capable of being used by your computer are listed in the table below.

Device(s)

Where to connect

Reference

CD-ROM drive (CF-VCD351)

Multimedia Pocket

below

PC Cards (Modem, LAN, SCSI, etc.)

PC Card Slots

page 23

Serial Devices (Mouse, Modem, etc.)

Serial Port

page 39

Extra Memory

RAM Module Slot

page 24

Port Replicator (CF-VEB351)

Expansion Bus Connector

page 25

External Display

Ext. Display Port

page 25

Printer

Parallel Port

page 25

Keyboard, External Mouse [Type PS/2], etc.

Ext. Keyboard/Mouse Port

page 39

Speaker/Headphone

Headphone Jack

page 39

Microphone

Microphone Jack

page 39

 

 

 

Using a CD-ROM Drive

You may use an optional CD-ROM pack (CF-VCD351) by removing your floppy disk drive from the multimedia pocket. Should you decide to install the CD-ROM pack, it will function as an internal CD-ROM drive. For more information, please read the manual that accompa- nies the CD-ROM pack.

Installing/Removing the Unit

1 Power off your computer ( page 10)

Do not shut down using the suspend or hibernation mode.

CAUTION

Do not install or remove peripherals while your computer is in the suspend or hibernation mode; abnormal operation may result.

MP Release Lever 2 Removing the unit

Turn your computer over, slide the MP release lever using thumb and remove the unit.

CAUTION

The lever will return to this position (right-side).

Please handle the unit as shown (holding both sides).

 

Otherwise, the unit may be damaged.

 

Do not allow dust to enter the multimedia pocket.

Groove

Use of the dummy FDD is highly recommended

 

when the floppy disk drive is not installed. When

 

inserting the dummy FDD, first make sure the guide

 

and groove match and then push the guide part of

 

the dummy FDD in.

Guide

Installing the unit

After the lever returns to its original position, continue pushing in the unit from both edges until it is firmly set.

3 Turn your computer on

CAUTION

You may use the floppy disk drive as an external unit that is connected through the parallel port, by using an optional FDD cable (CF-VCF351). Some precautions are necessary, as described below, since problems may arise.

•Do not move the drive while accessing data on the floppy disk.

•Firmly hold both sides of the drive when removing a disk. Excessive force on top should be avoided.

NOTE

Even after installing the CD-ROM Pack, [Removable Disk (A:)] is displayed in [My Com- puter], but access is not possible. Select [Cancel].

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents
Operating Instructions Illustrations in this Manual Customers RecordIntroduction CopyrightFor U.S.A Lithium BatteryHow to replace the fuse For U.KFor Germany PrecautionsFor France Saving Data on Floppy Disks Read Me FirstSaving Data on the Hard Disk Computer VirusesDummy FDD Operating Instructions First-time OperationConfirm the inclusion of all parts Windows 95 System PackHandling the AC adapter Connect your computer to a power outletRead the Limited USE Licence Agreement ClampsFirst-time Operation Starting Up/Shutting Down Starting UpStarting Up/Shutting Down Using the Touch PadShutting Down power off your computer Starting Up Your Computer QuicklyShutting Down Using the suspend functionUsing the hibernation function Resuming OperationComputing On the Road Conserving PowerSetting the hibernation timeout Things to RememberSetting Power Management Power Management settingsWhen the Remaining Battery Charge Becomes Low Battery StatusUse the Battery Indicator to Check on the Battery Status Computing On the RoadUsing the Battery Pack Using the Battery Pack Replacing the Battery PackTo disable your password When the User Password is setRun the Setup Utility Re-enter your password at the Enter User Password AgainTo disable the Coffee break Password Setting the Coffee break Password enabling or disablingWhen the coffee break password is set Security MeasuresPreventing the use of a floppy disk ProcedureWhen the supervisor password is set May be OpenedTo disable your supervisor password Setting the Supervisor PasswordEnabling, changing, disabling Preparations for Infrared Data Communications Infrared Data CommunicationsRunning TranXitTM Installing the unit Using a CD-ROM DriveInstalling/Removing the Unit Add-ons/PeripheralsInstalling the PC Card Using PC CardsInstalling/Removing the PC Card Type I orAdd-ons/Peripherals Installing/Removing the RAM ModuleInstalling the RAM module Adding MemoryUsing an External Display Connecting a Port ReplicatorUsing a Printer Installing/Removing the hard disk Maintenance Usage, Carrying and MaintenanceWhen flying Usage EnvironmentAt the MS-DOS prompt A\WINDOWS\COMMAND, input the following List of Error CodesUsing the Self-diagnosis Program Computer DiagnosisBattery Indicator Dealing with ProblemsStarting Up Disk Operations Dealing with ProblemsDisplay Character InputSetup Utility Connecting PeripheralsReinstalling Reinstalling SoftwareBefore Reinstallation PreparationDevice Manager System setupPower Management Video driverInstalling PhoenixCard Manager95 Reinstalling SoftwareInstalling TranXit Installing Internet ExplorerEnter your name and your company’s name, then press Windows 95 Setup ProcedureIf you want to complete the printer settings, press If not, pressClosing the Program Setup UtilityRunning the Setup Utility Key OperationsUser Password Main Specifications SpecificationsOther Specifications Names and Functions of Parts Limited USE License Agreement Lizenz Laufzeit der LizenzLicence Contrat de licence dusage limitéTermes, clauses et conditions LED indicators IndexDFQX2535YA