Panasonic CF-35 Connect your computer to a power outlet, Read the Limited USE Licence Agreement

Page 7

1	2 Connect your computer to a power outlet
	CAUTION
	Handling the AC adapter
2	Do not twist or pull the AC power cord forcefully. Doing so may damage the

connections.

Use only the specified AC adapter (factory control number: CF-AA1526) with your computer. Using an AC adapter other than the one supplied might damage

3	the battery and/or the computer.

	When the DC plug is not connected to the computer, disconnect the AC cord
	from your AC wall outlet as well. If the cord is kept connected, a very low level
	of power equivalent to approximately 1.1 watts* will be consumed.
	*When the battery pack is not recharging or fully charged
	Problems such as sudden voltage drops/surges may arise during periods of thun-
	der and lightning. Since this could adversely affect your computer, the
	uninterruptible power source (UPS) is highly recommended.
	Please make sure that the ferrite core is always attached to the plug of the AC
	adapter and in its proper position.	Clamps

1The ferrite core can be removed by unlatching the clamps with a

pair of mini-pliers, etc.

2When reattaching the ferrite core, match the end of the ferrite core to the third groove from the bottom of the plug (see diagram)

before closing it.

3 Read the LIMITED USE LICENCE AGREEMENT ( page 34)

To open the display, slide the latch located at the front and lift open the display. Before removing the seal covering the power switch, please read the LIMITED USE LICENSE AGREEMENT. Removal of this seal indicates agreement to the terms specified. After you have agreed to the terms, you may turn your computer on.

CAUTION

Do not slide the power switch repeatedly.

After you have turned your computer off, you must wait ten seconds before you can turn it back on.

Move the power switch toward the rear direction and hold one second un-

Latch til the power indicator ( ) goes on before re- leasing it.

7

Image 7

Contents Operating Instructions Copyright Customers RecordIntroduction Illustrations in this ManualFor U.K Lithium BatteryHow to replace the fuse For U.S.AFor Germany PrecautionsFor France Computer Viruses Read Me FirstSaving Data on the Hard Disk Saving Data on Floppy DisksWindows 95 System Pack First-time OperationConfirm the inclusion of all parts Dummy FDD Operating InstructionsClamps Connect your computer to a power outletRead the Limited USE Licence Agreement Handling the AC adapterFirst-time Operation Starting Up Starting Up/Shutting DownStarting Up Your Computer Quickly Using the Touch PadShutting Down power off your computer Starting Up/Shutting DownResuming Operation Using the suspend functionUsing the hibernation function Shutting DownThings to Remember Conserving PowerSetting the hibernation timeout Computing On the RoadPower Management settings Setting Power ManagementComputing On the Road Battery StatusUse the Battery Indicator to Check on the Battery Status When the Remaining Battery Charge Becomes LowUsing the Battery Pack Replacing the Battery Pack Using the Battery PackRe-enter your password at the Enter User Password Again When the User Password is setRun the Setup Utility To disable your passwordSecurity Measures Setting the Coffee break Password enabling or disablingWhen the coffee break password is set To disable the Coffee break PasswordMay be Opened ProcedureWhen the supervisor password is set Preventing the use of a floppy diskTo disable your supervisor password Setting the Supervisor PasswordEnabling, changing, disabling Preparations for Infrared Data Communications Infrared Data CommunicationsRunning TranXitTM Add-ons/Peripherals Using a CD-ROM DriveInstalling/Removing the Unit Installing the unitType I or Using PC CardsInstalling/Removing the PC Card Installing the PC CardAdding Memory Installing/Removing the RAM ModuleInstalling the RAM module Add-ons/PeripheralsUsing an External Display Connecting a Port ReplicatorUsing a Printer Installing/Removing the hard disk Usage Environment Usage, Carrying and MaintenanceWhen flying MaintenanceComputer Diagnosis List of Error CodesUsing the Self-diagnosis Program At the MS-DOS prompt A\WINDOWS\COMMAND, input the followingBattery Indicator Dealing with ProblemsStarting Up Character Input Dealing with ProblemsDisplay Disk OperationsConnecting Peripherals Setup UtilityPreparation Reinstalling SoftwareBefore Reinstallation ReinstallingVideo driver System setupPower Management Device ManagerInstalling Internet Explorer Reinstalling SoftwareInstalling TranXit Installing PhoenixCard Manager95If not, press Windows 95 Setup ProcedureIf you want to complete the printer settings, press Enter your name and your company’s name, then pressKey Operations Setup UtilityRunning the Setup Utility Closing the ProgramUser Password Main Specifications SpecificationsOther Specifications Names and Functions of Parts Limited USE License Agreement Laufzeit der Lizenz LizenzLicence Contrat de licence dusage limitéTermes, clauses et conditions Index LED indicatorsDFQX2535YA