Panasonic PT-DW6300U When multiple projectors are connected as part, Press the ID SET button

		About Your Projector
 Setting projector ID number to	 Using a wired remote control
remote control	When multiple projectors are connected as part of the
Each projector can be assigned a unique 2 digits ID	system, connect to units with a M3 stereo mini jack
	commercial cable to simultaneously control multiple main
number, and the remote control 2 digits ID number must
	units with a single remote control through the REMOTE 1
be set to match the intended projector. The default
	IN/OUT terminal. It is effective to use the wired remote
setting of the projector ID is ALL. Set the ID of the
	control in the environment in which an obstacle stands in
projector in advance from the menu items.
	the light path or where devices are susceptible to outside
1.Press the ID SET button.
	light.
 Displays the projector ID number on the screen.
2.Within 5 seconds, enter the same number of the required
projector by pressing the numeric buttons.
 ID number range: 01 - 64

Preparation

NOTE:

•Do not press the ID SET button accidentally or carelessly because the ID number on the remote control can be set even when no projector is around.

•If you do not enter the 2 digits ID number within 5 seconds after the ID SET button has been pressed, the ID will remain at the number that was set before the ID SET button was pressed.

•Your specified ID will be erased if the batteries of the remote control are left exhausted. When the batteries are replaced, set the same ID number again.

Connect to another projector

M3 stereo mini jack (commercial)

Connect to the remote control wired terminal

NOTE:

•Use 2 core shielded cable of length of 15 m or less. If the length of the cable exceeds 15 m (49'2"), the shielding of the cable may not be sufficient and the remote control may not work.

ENGLISH - 15