Panasonic PT-L6510U manual Tv-System, BAL White balance R/G/B, Signal Mode, Standard

TV-SYSTEM

(for composite/S-video only)

TV-SYSTEMAUTO1

AUTO2

NTSC

NTSC4.43

PAL

PAL-M

PAL-N

SECAM

AUTO1: Automatically selects the TV standard that matches the input video signal, out of NTSC, PAL, NTSC4.43, and SECAM.

AUTO2: Automatically selects the TV standard that matches the input video signal, out of NTSC, PAL-M, and PAL-N.

•Normally “AUTO1” or “AUTO2” should be chosen for this option.

•If input video signal quality is poor, choose the TV system that matches the input video signal.

Automatically selected by detecting the horizontal/vertical scan frequencies and color sub-carrier listed in the table below:

	H . Scan	V . Scan	Color
T a b l e	Frequency	Frequency	Subcarrier
	(kHz)	(Hz)	(MHz)
N T S C	1 5 . 7 5	6 0 . 0 0	3 . 5 8
N T S C 4 . 4 3	1 5 . 7 5	6 0 . 0 0	4 . 4 3
P A L	1 5 . 6 3	5 0 . 0 0
P A L - M	1 5 . 7 5	6 0 . 0 0	3 . 5 8
P A L - N	1 5 . 6 3	5 0 . 0 0
S E C A M	1 5 . 6 3	5 0 . 0 0	4 . 25 or 4 . 41

W.BAL (White balance) R/G/B

(for RGB/DVI signals only)

White balance may be adjusted for each color to correct reddish or bluish tones in white portions of the picture:

button: Deepens the selected color. button: Weakens the selected color.

Note

•Separate sets of adjustment parameters can be saved for the RGB1, RGB2 and DVI inputs.

SIGNAL MODE

(for RGB/YPBPR/DVI signals only)

“SIGNAL MODE” displays the names of the signals (resolution) presently applied to the RGB or YPBPR input ports. For details of signal names, see the table on page 48.

If the user mode is registered, the following menu will appear. You can choose either “AUTO” or a registered user setting from “USER1” to “USER3” with the or buttons.

SIGNAL MODE AUTO

USER1

If “AUTO” is chosen, a setting closest to the user setting is automatically selected. (In the example above, only “USER1” is registered for user address.)

Note

•If you choose a user address registered for a signal that does not match the input signal, it is regarded as no signal, and the projector will display the specified background color.

STANDARD

Pressing the “ENTER” button resets all the adjustment parameter values to the factory default values, with a “STANDARD” indicator shown on the upper right corner of the menu.

31