Zebra Technologies H 2824-Z user manual Operator Controls, Power Switch, Feed Button, Status Light

Page 23

Getting Started

Operator Controls

Operator Controls

Power Switch

Press backward to turn ON or forward to OFF the printer.

Caution • The power should be turned off before connecting or disconnecting the communications and power cables.

Feed Button

•Tapping the Feed button forces the printer to feed one blank label.

•Holding the Feed button forces the printer to feed continuously.

•Pressing the Feed button takes the printer out of a “pause” condition. The printer is put into “pause” by either a programming command or an error condition. See “What the Status Light is Telling You” in the Troubleshooting chapter.

•Use the Feed button for printer setup and status (see “Feed Button Modes” in the Troubleshooting chapter).

Status Light

Functions as a printer operational indicator (see “What the Status Light is Telling You” in the Troubleshooting chapter).

Feed Status

Button Light

Power

Switch

22

LP 2824-Z User Guide

980531-001 A

Image 23

Contents 2824-Z User Guide Customer Order # 980531-001 a FCC Compliance Statement Proprietary StatementProduct Improvements Limitation of Liability Canadian DOC Compliance StatementLiability Disclaimer Contacts PrefaceSupport Environmental ManagementDocument Conventions Related Documents Preface Contents Operations & Options Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterAfter opening the printer, check the media compartment Reporting Damage Closing the printerIntroduction Modes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Status Light Power SwitchOperator Controls Feed ButtonPrinting a Test Label Interface Cable Requirements Hooking Up the Printer and ComputerEthernet Interface Requirements Communicating with the PrinterAdjusting the Print Quality Adjusting the Print WidthOperations & Options Thermal Printing Replacing Supplies XA MMP XZ XA JUS XZ Printing in Peel-ModeOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Cleaning MaintenancePrint Head Considerations Media Path Considerations Sensors Platen Considerations LubricationRemoval Replacing the PlatenReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is on and in an idle state TroubleshootingResolutions Printer is not receiving powerEither the media or ribbon is out Printer has failed its power on self test PostThere is a shortage of memory Printer is receiving dataFlash memory is not programmed Print head is under temperaturePrint head is over temperature Printed image does not look right Print Quality ProblemsRibbon sensor settings did not print No print on the labelLabel format was sent to, but not recognized by, the printer Manual Calibration Recalibration Troubleshooting TestsPrinting a Configuration Label Communications Diagnostics Resetting the Factory Default ValuesFeed Button Modes Power Off Mode Communications Diagnostics ModeBattery Interfaces Universal Serial Bus USB Connector33-34 Parallel InterfaceRx+ ZebraNet PrintServer II for Ethernet NetworksSerial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp