Zebra Technologies H 2824-Z user manual Serial RS-232 Connector

Page 59

Interfaces

Serial (RS-232) Connector

Serial (RS-232) Connector

Pin No.	Description

1	Not used

2	RXD (receive data) input to the printer

3	TXD (transmit data) output from printer

4	DTR (data terminal ready) output from the printer -- controls when the
	host may send data

5	Chassis ground

6	DSR (data set ready) input to the printer

7	RTS (request to send) output from the printer -- always in the ACTIVE
	condition when the printer is turned on

8	CTS (clear to send) input to the printer

9	+5 V @ 0.75 A fused

The maximum current available through the serial and/or parallel port is not to exceed a total of 0.75 Amps.

When XON/XOFF handshaking is selected, data flow is controlled by the ASCII control codes DC1 (XON) and DC3 (XOFF). The DTR control lead will have no effect.

Interconnecting to DTE Devices —The printer is configured as data terminal equipment (DTE). To connect the printer to other DTE devices (such as the serial port of a personal computer), use an RS-232 null modem (crossover) cable.

Interconnecting to DCE Devices —When the printer is connected via its RS-232 interface to data communication equipment (DCE) such as a modem, a STANDARD RS-232 (straight- through) interface cable must be used.

58

LP 2824-Z User Guide

980531-001 A

Image 59

Contents 2824-Z User Guide Customer Order # 980531-001 a FCC Compliance Statement Proprietary StatementProduct Improvements Limitation of Liability Canadian DOC Compliance StatementLiability Disclaimer Contacts PrefaceSupport Environmental ManagementDocument Conventions Related Documents Preface Contents Operations & Options Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterAfter opening the printer, check the media compartment Reporting Damage Closing the printerIntroduction Modes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Status Light Power SwitchOperator Controls Feed ButtonPrinting a Test Label Interface Cable Requirements Hooking Up the Printer and ComputerEthernet Interface Requirements Communicating with the PrinterAdjusting the Print Quality Adjusting the Print WidthOperations & Options Thermal Printing Replacing Supplies XA MMP XZ XA JUS XZ Printing in Peel-ModeOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Cleaning MaintenancePrint Head Considerations Media Path Considerations Sensors Platen Considerations LubricationRemoval Replacing the PlatenReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is on and in an idle state TroubleshootingResolutions Printer is not receiving powerEither the media or ribbon is out Printer has failed its power on self test PostThere is a shortage of memory Printer is receiving dataFlash memory is not programmed Print head is under temperaturePrint head is over temperature Printed image does not look right Print Quality ProblemsRibbon sensor settings did not print No print on the labelLabel format was sent to, but not recognized by, the printer Manual Calibration Recalibration Troubleshooting TestsPrinting a Configuration Label Communications Diagnostics Resetting the Factory Default ValuesFeed Button Modes Power Off Mode Communications Diagnostics ModeBattery Interfaces Universal Serial Bus USB Connector33-34 Parallel InterfaceRx+ ZebraNet PrintServer II for Ethernet NetworksSerial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp