Zebra Technologies H 2824-Z user manual Printing in Peel-Mode, Xa Mmp Xz Xa Jus Xz

Page 31

Operations & Options

Printing in Peel-Mode

Printing in Peel-Mode

The optional dispenser allows you to print in “peel-mode” where the label backing follows a different path and the labels are presented one at a time for subsequent placement.

Before using peel-mode, you must send the programming commands to the printer.

^XA ^MMP ^XZ ^XA ^JUS ^XZ

Refer to your ZPL II Programmer’s Manual.

1.Remove several labels from the backing material.

2.Open the top cover.

3.Open the dispenser door.

4.Using a stylus, switch on the label-taken sensor.

5.Insert the backing in front of the peel bar and behind the peel roller.

6.Close the dispenser door.

7.Close the top cover.

8.Press the Feed button to advance the label.

9.During the print job, the printer will peel off the backing and present a single label. Take the label from the printer so it will print the next label.

30

LP 2824-Z User Guide

980531-001 A

Image 31
Contents 2824-Z User Guide Customer Order # 980531-001 a Product Improvements Proprietary StatementFCC Compliance Statement Liability Disclaimer Canadian DOC Compliance StatementLimitation of Liability Contacts PrefaceDocument Conventions Environmental ManagementSupport Related Documents Preface Contents Operations & Options Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterAfter opening the printer, check the media compartment Reporting Damage Closing the printerIntroduction Modes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Status Light Power SwitchOperator Controls Feed ButtonPrinting a Test Label Interface Cable Requirements Hooking Up the Printer and ComputerEthernet Interface Requirements Communicating with the PrinterAdjusting the Print Quality Adjusting the Print WidthOperations & Options Thermal Printing Replacing Supplies XA MMP XZ XA JUS XZ Printing in Peel-ModeOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Cleaning MaintenancePrint Head Considerations Media Path Considerations Sensors Platen Considerations LubricationRemoval Replacing the PlatenReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is on and in an idle state TroubleshootingResolutions Printer is not receiving powerEither the media or ribbon is out Printer has failed its power on self test PostThere is a shortage of memory Printer is receiving dataPrint head is over temperature Print head is under temperatureFlash memory is not programmed Printed image does not look right Print Quality ProblemsRibbon sensor settings did not print No print on the labelLabel format was sent to, but not recognized by, the printer Manual Calibration Printing a Configuration Label Troubleshooting TestsRecalibration Communications Diagnostics Resetting the Factory Default ValuesFeed Button Modes Power Off Mode Communications Diagnostics ModeBattery Interfaces Universal Serial Bus USB Connector33-34 Parallel InterfaceRx+ ZebraNet PrintServer II for Ethernet NetworksSerial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp