Zebra Technologies H 2824-Z user manual Media Path Considerations

Page 38

Maintenance

Cleaning

Media Path Considerations

Use a cleaning swab or pen to remove debris, dust or crust that has built-up on the holders, guides and media path surfaces.

1.Use the alcohol in the cleaning swab or pen to soak the debris so that it breaks up.

2.Wipe the knobs to remove accumulated debris.

3.Wipe the inside edges of both edge guides to remove any built-up residue.

4.Wait one minute before closing the printer.

Discard the cleaning swab or pen after use.

Knobs	Edge
	Guides
Platen

980531-001 A

LP 2824-Z User Guide

37

Image 38

Contents 2824-Z User Guide Customer Order # 980531-001 a FCC Compliance Statement Proprietary StatementProduct Improvements Limitation of Liability Canadian DOC Compliance StatementLiability Disclaimer Preface ContactsSupport Environmental ManagementDocument Conventions Related Documents Preface Contents Operations & Options Introduction HelloWhat’s in the Box? Inspecting the Printer Opening the printerAfter opening the printer, check the media compartment Closing the printer Reporting DamageIntroduction Getting Started Modes of PrintingAttaching Power Supply Adjusting the Roll Holders Loading Roll MediaPlacing the Roll in the Media Compartment Adjusting the Guides Feed Button Power SwitchOperator Controls Status LightPrinting a Test Label Hooking Up the Printer and Computer Interface Cable RequirementsCommunicating with the Printer Ethernet Interface RequirementsAdjusting the Print Width Adjusting the Print QualityOperations & Options Thermal Printing Replacing Supplies Printing in Peel-Mode XA MMP XZ XA JUS XZOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Maintenance CleaningPrint Head Considerations Media Path Considerations Sensors Lubrication Platen ConsiderationsReplacing the Platen RemovalReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is not receiving power TroubleshootingResolutions Printer is on and in an idle statePrinter is receiving data Printer has failed its power on self test PostThere is a shortage of memory Either the media or ribbon is outFlash memory is not programmed Print head is under temperaturePrint head is over temperature No print on the label Print Quality ProblemsRibbon sensor settings did not print Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Recalibration Troubleshooting TestsPrinting a Configuration Label Resetting the Factory Default Values Communications DiagnosticsPower Off Mode Communications Diagnostics Mode Feed Button ModesBattery Universal Serial Bus USB Connector InterfacesParallel Interface 33-34ZebraNet PrintServer II for Ethernet Networks Rx+Serial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp