Zebra Technologies H 2824-Z user manual Replacing the LP Print Head

Page 44

Maintenance

Replacing the Print Head

Replacing the LP Print Head (Continued)

Assembly

1.Align the print head to plug the left and right connectors into the wire bundles.

2.Slip the ground wire under the right screw and use a #1 Phillips driver to tighten it.

3.Slide the print head into one side and jog it into the other side.

4.Align the pivots of the bracket onto the posts; then, snap the bracket into place.

5.Clean the print head with the cleaning pen.

Reload media. Plug in the power cord, turn on the printer and print a status report to ensure proper function.

A

C

B

980531-001 A

LP 2824-Z User Guide

43

Image 44

Contents 2824-Z User Guide Customer Order # 980531-001 a FCC Compliance Statement Proprietary StatementProduct Improvements Limitation of Liability Canadian DOC Compliance StatementLiability Disclaimer Preface ContactsSupport Environmental ManagementDocument Conventions Related Documents Preface Contents Operations & Options Introduction HelloWhat’s in the Box? Inspecting the Printer Opening the printerAfter opening the printer, check the media compartment Closing the printer Reporting DamageIntroduction Getting Started Modes of PrintingAttaching Power Supply Adjusting the Roll Holders Loading Roll MediaPlacing the Roll in the Media Compartment Adjusting the Guides Power Switch Operator ControlsFeed Button Status LightPrinting a Test Label Hooking Up the Printer and Computer Interface Cable RequirementsCommunicating with the Printer Ethernet Interface RequirementsAdjusting the Print Width Adjusting the Print QualityOperations & Options Thermal Printing Replacing Supplies Printing in Peel-Mode XA MMP XZ XA JUS XZOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Maintenance CleaningPrint Head Considerations Media Path Considerations Sensors Lubrication Platen ConsiderationsReplacing the Platen RemovalReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Troubleshooting ResolutionsPrinter is not receiving power Printer is on and in an idle statePrinter has failed its power on self test Post There is a shortage of memoryPrinter is receiving data Either the media or ribbon is outFlash memory is not programmed Print head is under temperaturePrint head is over temperature Print Quality Problems Ribbon sensor settings did not printNo print on the label Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Recalibration Troubleshooting TestsPrinting a Configuration Label Resetting the Factory Default Values Communications DiagnosticsPower Off Mode Communications Diagnostics Mode Feed Button ModesBattery Universal Serial Bus USB Connector InterfacesParallel Interface 33-34ZebraNet PrintServer II for Ethernet Networks Rx+Serial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp