Zebra Technologies H 2824-Z user manual Thermal-Transfer LP Model

Page 43

Maintenance

Replacing the Print Head

Thermal-Transfer LP Model

Before following the steps in this procedure, open the printer by pulling the release latches forward then lifting the top cover.

Removal

1.Grasp the print head spring and pull it to the left; then, slide it free of the carriage.

2.Use the spring to pry the print head clip off the right side of the carriage.

3.Pull the print head and bracket forward.

4.Use a #2 Phillips driver to remove the screw that holds the ground wire.

5.Unplug both bundles of print head wires from their connectors.

A

C

B

42

LP 2824-Z User Guide

980531-001 A

Image 43

Contents 2824-Z User Guide Customer Order # 980531-001 a Product Improvements Proprietary StatementFCC Compliance Statement Liability Disclaimer Canadian DOC Compliance StatementLimitation of Liability Contacts PrefaceDocument Conventions Environmental ManagementSupport Related Documents Preface Contents Operations & Options Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterAfter opening the printer, check the media compartment Reporting Damage Closing the printerIntroduction Modes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Status Light Power SwitchOperator Controls Feed ButtonPrinting a Test Label Interface Cable Requirements Hooking Up the Printer and ComputerEthernet Interface Requirements Communicating with the PrinterAdjusting the Print Quality Adjusting the Print WidthOperations & Options Thermal Printing Replacing Supplies XA MMP XZ XA JUS XZ Printing in Peel-ModeOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Cleaning MaintenancePrint Head Considerations Media Path Considerations Sensors Platen Considerations LubricationRemoval Replacing the PlatenReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is on and in an idle state TroubleshootingResolutions Printer is not receiving powerEither the media or ribbon is out Printer has failed its power on self test PostThere is a shortage of memory Printer is receiving dataPrint head is over temperature Print head is under temperatureFlash memory is not programmed Printed image does not look right Print Quality ProblemsRibbon sensor settings did not print No print on the labelLabel format was sent to, but not recognized by, the printer Manual Calibration Printing a Configuration Label Troubleshooting TestsRecalibration Communications Diagnostics Resetting the Factory Default ValuesFeed Button Modes Power Off Mode Communications Diagnostics ModeBattery Interfaces Universal Serial Bus USB Connector33-34 Parallel InterfaceRx+ ZebraNet PrintServer II for Ethernet NetworksSerial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp