Zebra Technologies H 2824-Z user manual Parallel Interface, 33-34

Page 57

Interfaces

Parallel Interface

Parallel Interface

The maximum current available through the interface port is not to exceed a total of 0.75 amps.

Pin No.

Description

 

 

1

NStrobe/Host Clk

 

 

2-9

Data Bits 1-8

 

 

10

nACK/PtrClk

 

 

11

Busy/Per Busy

 

 

12

PError/ACK Dat Req.

 

 

13

Select/Xflag

 

 

14

NAuto Fd/Host Busy

 

 

15

Not Used

 

 

16-17

Ground

 

 

18

+5 V @ 0.75 A Fused

 

 

19-30

Ground

 

 

31

nInit

 

 

32

NFault/nData Avail.

 

 

33-34

Not Used

 

 

35

+5 V throught 1.8 K Ohms Resistor

 

 

36

NSelectin/1284 active

 

 

56

LP 2824-Z User Guide

980531-001 A

Image 57
Contents 2824-Z User Guide Customer Order # 980531-001 a Proprietary Statement Product ImprovementsFCC Compliance Statement Canadian DOC Compliance Statement Liability DisclaimerLimitation of Liability Contacts PrefaceEnvironmental Management Document ConventionsSupport Related Documents Preface Contents Operations & Options Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterAfter opening the printer, check the media compartment Reporting Damage Closing the printerIntroduction Modes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Operator Controls Power SwitchFeed Button Status LightPrinting a Test Label Interface Cable Requirements Hooking Up the Printer and ComputerEthernet Interface Requirements Communicating with the PrinterAdjusting the Print Quality Adjusting the Print WidthOperations & Options Thermal Printing Replacing Supplies XA MMP XZ XA JUS XZ Printing in Peel-ModeOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Cleaning MaintenancePrint Head Considerations Media Path Considerations Sensors Platen Considerations LubricationRemoval Replacing the PlatenReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Resolutions TroubleshootingPrinter is not receiving power Printer is on and in an idle stateThere is a shortage of memory Printer has failed its power on self test PostPrinter is receiving data Either the media or ribbon is outPrint head is under temperature Print head is over temperatureFlash memory is not programmed Ribbon sensor settings did not print Print Quality ProblemsNo print on the label Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Troubleshooting Tests Printing a Configuration LabelRecalibration Communications Diagnostics Resetting the Factory Default ValuesFeed Button Modes Power Off Mode Communications Diagnostics ModeBattery Interfaces Universal Serial Bus USB Connector33-34 Parallel InterfaceRx+ ZebraNet PrintServer II for Ethernet NetworksSerial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp