Zebra Technologies H 2824-Z user manual Related Documents

Page 8

Preface

Related Documents

Caution • Warns you of a situation where excessive heat could cause a burn.

Caution • Advises you that failure to take or avoid a specific action could result in physical harm to you.

Caution • Advises you that failure to take or avoid a specific action could result in physical harm to the hardware.

Caution • Advises you need to wear protective eyeware.

Important • Advises you of information that is essential to complete a task.

Note • Indicates neutral or positive information that emphasizes or supplements important points of the main text.

Example • Provides an example, often a scenario, to better clarify a section of text.

Tools • Tells you what tools you need to complete a given task.

Video • (online only) Links to a motion picture that demonstrates a procedure.

Related Documents

The following documents might be helpful references:

•ZPL II® Programming Guide Volume I (part number 45541L) and Volume II (part number 45542L).

•ZebraNet® Wireless Print Server User Guide (part number 13422L)

•ZebraNet 10/100 Print Server User and Reference Guide (part number 47619L-001)

•ZebraNet PrintServer II™ Installation and User Guide (part number 45537L)

•Universal Serial Bus Specification available from the USB Implementation Forum

980531-001 A

LP 2824-Z User Guide

7

Image 8

Contents 2824-Z User Guide Customer Order # 980531-001 a FCC Compliance Statement Proprietary StatementProduct Improvements Limitation of Liability Canadian DOC Compliance StatementLiability Disclaimer Preface ContactsSupport Environmental ManagementDocument Conventions Related Documents Preface Contents Operations & Options Introduction HelloWhat’s in the Box? Inspecting the Printer Opening the printerAfter opening the printer, check the media compartment Closing the printer Reporting DamageIntroduction Getting Started Modes of PrintingAttaching Power Supply Adjusting the Roll Holders Loading Roll MediaPlacing the Roll in the Media Compartment Adjusting the Guides Power Switch Operator ControlsFeed Button Status LightPrinting a Test Label Hooking Up the Printer and Computer Interface Cable RequirementsCommunicating with the Printer Ethernet Interface RequirementsAdjusting the Print Width Adjusting the Print QualityOperations & Options Thermal Printing Replacing Supplies Printing in Peel-Mode XA MMP XZ XA JUS XZOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Maintenance CleaningPrint Head Considerations Media Path Considerations Sensors Lubrication Platen ConsiderationsReplacing the Platen RemovalReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Troubleshooting ResolutionsPrinter is not receiving power Printer is on and in an idle statePrinter has failed its power on self test Post There is a shortage of memoryPrinter is receiving data Either the media or ribbon is outFlash memory is not programmed Print head is under temperaturePrint head is over temperature Print Quality Problems Ribbon sensor settings did not printNo print on the label Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Recalibration Troubleshooting TestsPrinting a Configuration Label Resetting the Factory Default Values Communications DiagnosticsPower Off Mode Communications Diagnostics Mode Feed Button ModesBattery Universal Serial Bus USB Connector InterfacesParallel Interface 33-34ZebraNet PrintServer II for Ethernet Networks Rx+Serial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp