Zebra Technologies 105Se manual 6WRUDJHDQG5HVKLSSLQJ, 3RZHU&RQQHFWLRQ, $&9ROWDJH6HOHFWLRQ3URFHGXUH

6WRUDJH￿DQG￿5HVKLSSLQJ

If you are not placing the printer into operation immediately, repackage it using the original packing materials. The S-Series Printer may be stored under the following conditions:

•Temperature: –40° to +158° F (–40° to +70° C)

•Relative humidity: 20% to 85% non-condensing

Should it become necessary to ship your printer, remove any ribbon and paper roll from the supply spools, otherwise damage to the printer could result. Carefully pack the printer in a suitable container to avoid damage during transit. Whenever possible, use the original container and packaging material from the factory. If you use a different container, a procedure similar to the original factory packaging should be followed.

&$87,21￿￿￿'R￿QRW￿SDFNDJH￿WKH￿SULQWHU￿LQ￿D￿ULJLG￿FRQWDLQHU￿

ZLWKRXW￿XWLOL]LQJ￿VKRFN￿PRXQWV￿RU￿VKRFN￿DEVRUELQJ￿SDFNLQJ￿ PDWHULDO￿￿￿$￿ULJLG￿FRQWDLQHU￿DOORZV￿VKRFN￿RQ￿WKH￿RXWVLGH￿WR￿EH￿ WUDQVPLWWHG￿XQGDPSHG￿WR￿WKH￿XQLW￿￿ZKLFK￿PD\￿FDXVH￿GDPDJH￿

3RZHU￿&RQQHFWLRQ

$&￿9ROWDJH￿6HOHFWLRQ￿3URFHGXUH

The S-Series Printer’s AC voltage may be set for either 115 VAC or 230 VAC operation. To match the printer’s power entry selection to the available power source, refer to Figure 1 and follow the procedure outlined below:

1.Locate the AC power area at the rear of the printer.

2.Using a small flatblade screwdriver or similar tool, move the voltage selection switch to the 115 V or 230 V position as required. (The initial position of the switch depends on how the printer was ordered.) Make sure that the appropriate fuse is in place.

8 Zebra S-Series User’s Guide