Zebra Technologies 105Se manual 5LEERQ/RDGLQJ6H

5LEERQ￿/RDGLQJ￿￿￿￿￿6H￿

Refer to Figure 4 throughout this procedure.

Note: When placing the ribbon roll on the ribbon supply spindle, make sure that the core is pushed up against the stop on the ribbon supply spindle and that the ribbon is aligned squarely with its core. If this is not done, the ribbon may not cover the inside edge of the printhead, exposing print elements to potentially damaging contact with the media.

Do not load ribbon if the printer is to be used in the direct thermal mode.

&$87,21￿￿￿'R￿QRW￿XVH￿ULEERQ￿WKDW￿LV￿QDUURZHU￿WKDQ￿WKH￿PHGLD￿￿￿,I￿ WKH￿SULQWKHDG￿LV￿QRW￿SURWHFWHG￿E\￿WKH￿VPRRWK￿EDFNLQJ￿RI￿WKH￿

ULEERQ￿￿H[FHVVLYH￿DEUDVLRQ￿PD\￿FDXVH￿SUHPDWXUH￿SULQWKHDG￿ IDLOXUH￿

1. Align the segments of the ribbon supply spindle. See Figure 2.

Figure 2

2.Place the ribbon roll on the ribbon supply spindle.

3.Open the printhead by moving the handle to the OPEN position.

Zebra S-Series User’s Guide 11