Zebra Technologies 105Se manual Then, cycle the power

SYMPTOM	DIAGNOSIS	ACTION
	Parameters are set or saved	Reload the factory defaults.
	incorrectly.	See “Calibration” on page 43
		and calibrate the printer.
Changes in parameter settings		Then, cycle the power
did not take effect.		ON/OFF switch.
	If problem continues, there	Call a service technician.
	may be a problem on the main
	logic board.
	Communications parameters	See “MODE Key Self Test” on
	or DIP switches are set	page 33. Check for format or
	incorrectly.	overrun errors. Reset
		communication parameters if
		needed.
ZPL II was sent to printer, but
	Prefix and delimiter characters	Set the characters in the
not recognized. The DATA	set in printer configuration do	printer to match ZPL II format
light remains off.	not match the ones sent in the	(see page 35). Check the
	ZPL II label formats.	configuration label for correct
		characters. If problem
		continues, check the ZPL II
		format for changed ^CC, ^CT,
		and ^CD instructions.
Printer does not operate in the	Bank 2 DIP switches set to	Check Bank 2 DIP switch
mode specified in ZPL II or by	override ZPL II and calibration.	settings. See page 41.
calibration.
	Printer not set up correctly.	See page 43 to recalibrate the
		printer. Also, see page 41 to
		check Bank 2 DIP switch
Printer does not feed media		settings.
with black marks correctly.
	Sensor is broken. (No red	Call a service technician.
	light is visible when looking
	through the front of the printer
	with the printhead open.)
In cutter mode, skewed or	Cutter is dirty.	Follow cutter module cleaning
stuck labels.		procedure on page 57.
	Cutter is dirty.	Follow cutter module cleaning
The cutter is not cutting labels		procedure on page 57.
cleanly.
	Cutter blades are dull.	Replace the cutter module.

Zebra S-Series User’s Guide 69