Zebra Technologies 105Se ÃlÞl›Ï‹ÞlÍA‹›Ïl›A›Yl, 2YHUYLHZ, Ohdqlqj, WHULRU6XUIDFHV, Qwhulru

-ÃlÞl›Ï‹ÞlÍ"A‹›Ïl›A›Yl

2YHUYLHZ

This section contains preventive maintenance information for the Zebra S-Series Printer. These procedures may be performed by the operator.

&OHDQLQJ

([WHULRU￿6XUIDFHV

The exterior surfaces of the printer may be cleaned as required by using a lint-free cloth. Do not use harsh or abrasive cleaning agents or solvents. If necessary, a mild detergent solution or desktop cleaner may be used sparingly.

,QWHULRU

Remove any accumulated dirt/lint from the interior of the printer using a soft bristle brush and/or vacuum cleaner. This area should be inspected after every four rolls of media.

&OHDQLQJ￿6FKHGXOH

AREA	METHOD	INTERVAL
Printhead	Isopropyl alcohol	After every roll of media (or 500
		ft. of fanfold media) when
Platen Roller	Isopropyl alcohol
		printing direct thermal or after
Upper and Lower Media	Air blow
		every roll of ribbon when printing
Sensors
		in thermal transfer mode.
Media Path	Isopropyl alcohol
Ribbon Sensor	Air blow
Peel/Tear Bar	Isopropyl alcohol	As needed.
Label Available Sensor	Air blow	Monthly.
Cutter Module	Isopropyl alcohol and/or air blow	As needed.

Table 4

Zebra S-Series User’s Guide 51