Zebra Technologies 105Se manual 6LWH5HTXLUHPHQWV, $87,217RHQVXUHWKDWWKH66HULHV3ULQWHUKDVSURSHU

￿￿￿￿9$&￿2SHUDWLRQ

1.Confirm that the voltage selector switch is set to 115 V.

2.Attach the supplied power cord to the AC power receptacle located on the rear of the printer.

3.Connect the opposite end of the power cord to a properly grounded source of 115 VAC (50 or 60 Hz) power rated for at least 5 Amps.

￿￿￿￿9$&￿2SHUDWLRQ

1.Confirm that the voltage selector switch is set to 230 V.

2.Depending on how the printer was ordered, a power cord may or may not be provided for 230 VAC operation. If not provided, obtain a cord set with the proper AC power plug. The cord may then be connected to the standard (international) IEC-type 3-prong AC connector provided on the S-Series Printer. Refer to “230 VAC Power Cord” on page 83 for more information.

6LWH￿5HTXLUHPHQWV

&$87,21￿￿￿7R￿HQVXUH￿WKDW￿WKH￿6￿6HULHV￿3ULQWHU￿KDV￿SURSHU￿

YHQWLODWLRQ￿DQG￿FRROLQJ￿￿GR￿QRW￿SODFH￿DQ\￿SDGGLQJ￿RU￿FXVKLRQLQJ￿ PDWHULDO￿RQ￿WKH￿EDFN￿RI￿RU￿XQGHUQHDWK￿WKH￿XQLW￿DV￿WKLV￿UHVWULFWV￿WKH￿ DLU￿IORZ￿

The S-Series Printer may be installed on any solid, level surface of sufficient size and strength to accommodate the unit. The area in which the printer operates must meet the environmental conditions specified (see page 77).

Since the Zebra S-Series Printer was designed and is fabricated as an industrial-type unit, it functions satisfactorily in areas such as a warehouse or factory floor that conform to the specified environmental and electrical conditions (see page 76).

10 Zebra S-Series User’s Guide