Zebra Technologies 105Se manual Necessary

SYMPTOM	DIAGNOSIS	ACTION
	Possible media sensor or	Adjust media sensor position
	calibration problem.	(see page 63) or calibrate
		media (see page 43). Call a
		service technician if
Loss of printing registration on		necessary.
labels.
	Printer set for non-continuous	Set printer for correct media.
	media, but continuous media	See See “Media Loading” on
	loaded.	page 15.
(For Peel-Off Mode)	Improperly adjusted media	Refer to “Media Loading” on
	edge guides.	page 15.
Excessive vertical drift in top-	Incorrect media loading.	See “Media Loading” on
of-form registration.		page 15.
	Dirty head or ribbon rollers.	See “Printhead and Platen
		Roller” on page 52 for
Light vertical lines running		printhead cleaning
through all labels.		instructions.
	Defective printhead elements.	Call a service technician.
Light printing or no printing on	Printhead needs balancing.	Adjust toggle pressure and/or
left or right side of the label.		position. See “Toggle
		Positioning” on page 59.
Short printed lines at 45° to	Too much printhead pressure.	Adjust toggle pressure and/or
label edge on left or right side		position. See “Toggle
of label.		Positioning” on page 59.
Fine gray lines on blank labels	Wrinkled ribbon.	See “Wrinkled ribbon.” on
at angles.		page 68 under SYMPTOM.
Truncated print, no print, or	Media or ribbon improperly	See “Media Loading” on
FEED button operates	loaded.	page 15; “Ribbon Loading
incorrectly while using non-		(105Se)” on page 11; and
continuous media.		“Ribbon Loading (160S)” on
		page 14.

Zebra S-Series User’s Guide 67