Zebra Technologies 105Se manual Wrinkled ribbon See Wrinkled ribbon. on

SYMPTOM	DIAGNOSIS	ACTION
	Wrinkled ribbon.	See “Wrinkled ribbon.” on
Long tracks of missing print on		page 68 under SYMPTOM.
several labels.
	Print element damaged.	Call a service technician.
	Glue material from back of	Refer to "Cleaning" beginning
	labels causing media	on page 51 and perform
In Peel-Off Mode, skewed or	movement problems.	maintenance and cleaning of
stuck labels.		the printer.
	Media and backing not	See “Media Loading” on
	properly aligned in printer.	page 15.
	Ribbon fed through machine	See “Ribbon Loading (105Se)”
	incorrectly.	on page 11 and “Ribbon
		Loading (160S)” on page 14.
	Incorrect darkness setting.	Set to the lowest value needed
		for good print quality. See
Wrinkled ribbon.		“Adjusting the Print Darkness”
		on page 44.
	Incorrect printhead position or	Adjust toggle pressure and/or
	pressure.	position. See page 59.
	Media not feeding properly; it	Make sure the media is snug
	is walking from side to side.	by adjusting the media guide.
		See “Media Loading” on
		page 15.
	Continuing symptoms.	Call a service technician.
Continued wrinkled ribbon.	Strip plate needs adjusting.	Call a service technician.
	Media was pulled when motor	Enter calibrate mode and
	was not moving.	recalibrate. See page 43.
	Incorrect media sensor	See media sensor position
Misregistration and misprint of	position.	adjustments on page 60.
	Media or ribbon improperly	See “Media Loading” on
1 to 3 labels.	loaded.	page 15; “Ribbon Loading
		(105Se)” on page 11; and
		“Ribbon Loading (160S)” on
		page 14.
	Incorrect media sensor	See “Media and Ribbon
	position or sensitivity.	Sensor Sensitivity Adjustment”
		on page 63.

68 Zebra S-Series User’s Guide