Zebra Technologies 105Se manual DQIROG6XSSO\%LQ, WHUQDO=HEUD1HWŒWKHUQHW,QWHUIDFH

)DQIROG￿6XSSO\￿%LQ

Your printer may be equipped with an optional internal fanfold supply bin. It is used to load fanfold media within the media compartment, and it protects the media from environmental contaminants such as dust and dirt.

The fanfold media supply bin is fully adjustable. It accommodates media from 1.57" (40 mm) to 3.54" (90 mm) wide (7.17" [183 mm] wide for the 160S) and 3.5" (89 mm) to 8" (203mm) long. The maximum stack height for 8" long media is 4.5". Stack heights of 6.5" may be achieved with media less than 3.5" long.

The fanfold supply bin may be installed in the field by the operator. To install the fanfold supply bin, follow the instructions included with the option.

Note: The fanfold supply bin, peel-off option, and rewind option are mutually exclusive. The fanfold supply bin may not be installed in S-Series Printers with the peel-off option or the rewind option. Fanfold media may be used with the rewind spindle installed by using one of the external fanfold supply access slots (at the bottom and rear of the printer).

([WHUQDO￿=HEUD1HWŒ￿￿(WKHUQHW￿￿,QWHUIDFH

ZebraNet allows you to connect your printer to your ethernet network. This interface option is available for both 10Base-2 and 10Base-T networks.

%ODFN￿0DUN￿￿5HIOHFWLYH￿￿6HQVRU

Note: For the 105Se printer only.

The reflective sensor utilizes continuous media with black marks printed on the back of the label liner. The black mark sensor determines the label length and the top of the label by detecting the black mark (similar to the way a transmissive sensor detects the gap or notch).

This option is in addition to the standard transmissive sensor and is software- or switch-selectable.

80 Zebra S-Series User’s Guide