Installation and Reference for the BayStack 21 PCI 10/100 Adapter w/WOL
Installing the BayStack 21 PCI 10/100 Adapter w/WOL
To install the BayStack 21 network card in a workstation:
1.Shut down the workstation.
2.Unplug the workstation power cord from the power source.
3.Remove the chassis cover of the workstation.
4.Locate an available PCI bus master expansion slot in the workstation.
5.Remove the protective bracket from the slot.
6.Insert the contact edge of the BayStack 21 network card into the slot.
7.Make sure all edge connectors of the network card are firmly seated in the slot.
8.Install and secure the bracket screw to secure the network card to the chassis.
9.If you plan to install the WOL cable, proceed to “ Connecting the WOL Cable” on page
10.Replace the chassis.
11.Install a standard Ethernet cable to the BayStack 21 network card.
a.Plug one end of the network cable into the
b.Plug the other end of the network cable into an
12.Reconnect the power cord and turn the workstation on.
Note: If the Basic Input/Output System (BIOS) section of your workstation boot program is “Plug and Play” compliant, the BIOS will automatically configure a newly installed network card.
If the BIOS program has assigned your network card an interrupt number that is already assigned to another device, both devices will fault. If you detect this problem, you must run the CMOS Setup Utility to manually assign a nonconflicting interrupt number.
|