
Digital Label Press 3 User’s Manual
Getting Started
3
A. CHOOSING A GOOD LOCATION
Place the unit in a location with adequate air circulation to prevent internal heat build up.
Use the dimensions specified in Section 10 as a guideline for the minimum clearances to the unit.
NOTE: Allow for adequate clearance above the unit to accommodate the height of the unit with its cover open.
Do not place the unit in a location where the ventilation holes located on the left of the unit could become blocked.
Do not install unit near heat sources such as radiators or air ducts, or in a place subject to direct
B.ABOUT MOISTURE CONDENSATION
If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense inside the unit. Should this occur, print quality may not be optimum. Leave the unit turned off in a warm, dry room for several hours before using. This will allow the moisture to evaporate.
Section 3: Getting Started
9