
Digital Label Press 3 User’s Manual
Control Panel
Notice that Press's Control Panel LCD Display shows information on both cutting and printing. The reason for this is that each of these functions works independently of each other. This means that if the print job is canceled, for example, the cutter will continue to cut and vice- versa. The following describes the function of each button as well as the information found on the LCD display:
LCD Display
This display is used to convey useful information to the user. The following table shows some of the normal messages you will see during normal operation:
Message | Description |
|
|
POWER UP | This is displayed during “boot up” sequence when |
INITIALIZING | power has been applied to the unit. During this |
| sequence you will see helpful information on the |
| firmware version for both the cutter and the printer |
| displayed. |
|
|
PRINTER: READY | The press is ready to receive a job. |
CUTTER: READY |
|
|
|
#200 ABR (paper type) | This useful message identifies the type of paper |
QUANTITY: XXX | installed as well as the number of prints remaining |
(number of prints) | on the roll. Please refer to section |
| description of paper types shown in this display |
|
|
PAGE COUNT: XXXX | This message displays the number of pages that |
(number of prints) | have been printed since the press has been turned |
| on. This number can also be reset to "0". This is |
| described later in this section. |
Table 3.1. Normal Display Messages
More messages can be seen in Section 9: Troubleshooting.
Section 3: Getting Started
11