Nortel Networks 703t manual Part Color

Page 22

703t server description

Standard 1.04

The table below describes the parts that are identified in the preceding diagram:

Part

Color

 

 

AC power supply connector

Not applicable

(450 W non hot-swap power supply)

 

 

 

USB connectors

Not applicable

 

 

PS/2 keyboard connector

Purple

 

 

PS/2 mouse connector

Green

 

 

COM1 serial port connector (9-pin)

Teal

 

 

Parallel port connector (25-pin)

Pink

 

 

Monitor connector (15-pin)

Blue

 

 

10/100/1000Base-T CLAN network connector for

Not applicable

Customer LAN connection (NIC2 1 GB)

 

Note: For more information, see

 

“LAN connectivity” on page 28.

 

 

 

10/100Base-T ELAN network connector for

Not applicable

Meridian 1/Succession 1000 connection

 

(NIC1 10/100 MB)

 

Note: For more information, see

 

“LAN connectivity” on page 28.

 

 

 

PCI slots (6)

Not applicable

„Four slots are 100 MHz 3.3 V 64-bit PCI slots.

„Two slots are 33 MHz 5 V 32-bit PCI slots.

Note: For more information, see “Slot assignments” on page 23.

COM2 serial port connector slot (not installed)

Teal

 

 

22

CallPilot

Image 22
Contents 703t Server Hardware Installation Copyright 2006 Nortel Networks October Information for Japan があります。この場合には使用者が適切な対策を取るように要求されることがあ ります。 Standard Publication history Publication history Task List Task List Contents Contents A p t e r Getting Help over the phone from a Nortel Solutions CenterGetting Help from the Nortel Web site Getting Help through a Nortel distributor or reseller 703t server description This chapterServer features Server dimensionsEnvironmental specifications Front panel features CD-ROMServer in the Installation and Configuration 703t server descriptionStandard Rear panel diagram Part Color Slot assignments Slot definition and numbering BRD01Network connectivity Sample network setup Meridian Sample network setup Succession Telephony LAN/Customer LAN 10/100/1000Base-TSwitch connectivity LAN connectivityRemote access connectivity Network requirementsSupported peripheral devices Reference documents CallPilot Customer Documentation Map703t server description Preinstallation requirements Installation checklist Installation overviewIntroduction October 2006Preinstallation requirements Conventions for warnings Unpacking the 703t server To unpack the equipmentWhat’s next? Removing the side cover To remove the side panelG101761 October Inspecting the server interior To inspect the server interiorReplacing the side cover To replace the side coverTop Installing the chassis feet To install the chassis feetWhat’s next? Installing the server and connecting the peripheral devices Installing the server To install the serverPreparing the modem Modem DIP switchesRequired equipment DIP To set the modem DIP switches OFFNvram Connecting peripherals to the server Rear panelInstalling the server and connecting the peripheral devices To connect the mouse, keyboard, and monitor to the server To connect the modem to the serverInstalling the server and connecting the peripheral devices Connect the server to the Elan and Clan hubs if applicable Connecting the server to the Elan Your network, see the Planning and Engineering GuideRisk of fire hazard Connecting the server to the Clan optional To connect the server to the ClanInstalling the Nortel software feature dongle To install the software feature dongle RequirementsConnecting the server to power Before you beginCallPilot Server To connect the server to power To start the serverInstalling the server and connecting the peripheral devices Index NumericsDIP switches, setting October Index Standard Page 703t Server Hardware Installation