Nortel Networks 703t manual Connecting the server to the Clan optional

Page 60

Installing the server and connecting the peripheral devices

Standard 1.04

Connecting the server to the CLAN (optional)

This section provides instructions to connect the server to the Customer LAN (CLAN).

Note: The CLAN connection is optional. However, connection to a CLAN is required for support of desktop and web messaging users, or administration by means of a web-enabled PC. Make sure that your latest antivirus programs and Nortel security updates are installed.

ATTENTION

 

To comply with EMC requirements, a Class A hub must be

 

 

located 10 m (33 feet) away from the 703t server.

To connect the server to the CLAN

1Locate the CLAN connector on the back of the server.

Note: The CLAN connector is labeled as NIC2 1GB. For the connector location, see the diagram on page 54.

2Connect an RJ-45 network cable from the CLAN hub to the CLAN connector.

Note: When connecting the optional CLAN, do not power up unless your antivirus programs and Nortel security updates are installed first.

What’s next?

Continue with “Installing the Nortel software feature dongle” on page 61.

60

CallPilot

Image 60
Contents 703t Server Hardware Installation Copyright 2006 Nortel Networks October Information for Japan があります。この場合には使用者が適切な対策を取るように要求されることがあ ります。 Standard Publication history Publication history Task List Task List Contents Contents Getting Help over the phone from a Nortel Solutions Center A p t e rGetting Help from the Nortel Web site Getting Help through a Nortel distributor or reseller 703t server description This chapterServer features Server dimensionsEnvironmental specifications Front panel features CD-ROMServer in the Installation and Configuration 703t server descriptionStandard Rear panel diagram Part Color Slot assignments Slot definition and numbering BRD01Network connectivity Sample network setup Meridian Sample network setup Succession Telephony LAN/Customer LAN 10/100/1000Base-TSwitch connectivity LAN connectivityRemote access connectivity Network requirementsSupported peripheral devices Reference documents CallPilot Customer Documentation Map703t server description Preinstallation requirements Installation overview Installation checklistIntroduction October 2006Preinstallation requirements Conventions for warnings Unpacking the 703t server To unpack the equipmentWhat’s next? Removing the side cover To remove the side panelG101761 October Inspecting the server interior To inspect the server interiorReplacing the side cover To replace the side coverTop Installing the chassis feet To install the chassis feetWhat’s next? Installing the server and connecting the peripheral devices Installing the server To install the serverModem DIP switches Preparing the modemRequired equipment DIP To set the modem DIP switches OFFNvram Connecting peripherals to the server Rear panelInstalling the server and connecting the peripheral devices To connect the mouse, keyboard, and monitor to the server To connect the modem to the serverInstalling the server and connecting the peripheral devices Connect the server to the Elan and Clan hubs if applicable Connecting the server to the Elan Your network, see the Planning and Engineering GuideRisk of fire hazard Connecting the server to the Clan optional To connect the server to the ClanInstalling the Nortel software feature dongle To install the software feature dongle RequirementsConnecting the server to power Before you beginCallPilot Server To connect the server to power To start the serverInstalling the server and connecting the peripheral devices Index NumericsDIP switches, setting October Index Standard Page 703t Server Hardware Installation