Nortel Networks 703t manual Preparing the modem, Required equipment, Modem DIP switches

October 2006 Installing the server and connecting the peripheral devices

Preparing the modem

You require a modem to support remote dial-up access to the CallPilot server. The modem also enables Nortel technical support to connect to your CallPilot server for troubleshooting purposes. Nortel connects to your server only when you request technical assistance.

Required equipment

To install the modem, you need the following equipment:

„an analog external modem that includes

„an RJ-11 analog phone cord

„a power adapter cord

„US Robotics 56 Kbps modem (NTRH9078) (North America only)

„a 25-pin male to 9-pin female shielded serial cable for your modem (A0841984)

„an analog line jack

„tweezers, or a screwdriver small enough to use to adjust DIP switches

Modem DIP switches

Set the modem DIP switches before you connect the modem to the CallPilot server.

Note: This section applies only to the US Robotics 56 Kbps external Sportster modem. If your modem is different, refer to the documentation for your modem.

703t Server Hardware Installation 49