Nortel Networks NN44200-300 manual Removing the front bezel and server cover, What is next?

Removing the front bezel and server cover 27

What is next?

Remove the server cover so that you can inspect the interior of the server. See "Removing the front bezel and server cover" (page 27).

Removing the front bezel and server cover

Introduction

To access the server interior, you must remove both the front bezel and the server cover.

Two locked doors, located on the front of the server, cover the front panel, including the CD-ROM drive and tape drive. These doors are part of the front bezel. You must unlock the front bezel doors before you can remove the bezel.

To remove the front bezel

Step Action

CAUTION

Do not attempt to move or lift the server before removing the front bezel; the server can disengage from the bezel and fall.

1Unlock and open the double doors of the front bezel. See A in the diagram below.

2Firmly grasp the front bezel by the hand-holds on either side of the chassis, and pull the front bezel from the chassis.

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300 01.01 Standard

5.0 23 February 2007

Copyright © 2007, Nortel Networks Nortel Networks Confidential