Nortel Networks NN44200-300 manual Power supply installation

Page 38

38Chapter 4 Power supply installation

Note: The cables are marked with Red and Green tape. The cables with the Red tape connect to the Negative (-) Red side (on the left in the photograph), and the cables with the Green tape connect to the Positive

(+)Green side (on the right in the photograph). The sides are identiﬁed on the power connections. The ground wire enters at the lower right and attaches to the ground lug.

Main panel wiring diagram with product number.

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300 01.01 Standard

5.0 23 February 2007

Copyright © 2007, Nortel Networks

Nortel Networks Conﬁdential

Image 38

Contents 1002rp Server Hardware Installation Trademarks Japan Vcci statement Information for JapanJapan Denan statement Page Publication History FebruaryPublication History Contents Contents Getting help over the phone from a Nortel Solutions Center Getting help from the Nortel Web siteGetting help through a Nortel distributor or reseller This chapter Server featuresServer dimensions and weight IntroductionFront panel features front view without the front bezel Environmental speciﬁcationsAlarm board Rear panel diagramOverhead view of empty server showing PCI and ISA connectors Slot assignments Reference Documents1002rp server description Slot deﬁnition and slot numbering T1/SMDINetwork connectivity BRD20Sample network setup Meridian Sample network setup Communication ServerMeridian 1 or Communication Server 1000 systems Switch connectivityCallPilot Elan subnet and Nortel server subnet setup Network requirementsRemote access connectivity Supported peripheral devicesDeviceDescription Installation overview Installation checklistPreparing for installation Conventions for warnings Unpacking the 1002rp server To unpack the equipmentTo remove the front bezel What is next?Removing the front bezel and server cover To remove the server cover Remove the front bezel see To remove the front bezelInspecting the server interior To inspect the server interiorTo replace the front bezel after installation is complete Installation and ConfigurationEnd Preparing for installation Equipment handling guidelines Safety precautionsSafety information AC versus DC systems Installing the second power supply module AC or DCAbout the power supply module To install the power supply module DC wire gauge tables AWGMetric wire conversion DC rack cablingPower supply installation Rack power and grounding PDU power and grounding About the power distribution unitDC power distribution rationale Multiple PDUsPDU terminal blocks and wiring diagram DC power inputBringing power and ground into the PDU To bring DC power and ground into the PDUInstalling the server To install the serverRequired equipment Modem DIP switchesPreparing the modem To set the modem DIP switches DIPContinue with Connecting peripherals to the server Connecting peripherals to the server To connect the modem to the server To connect the server to the Elan subnet Connecting the server to the Elan subnetMedia Access Control address Server will Connecting the server to the Nortel server subnet optional To connect the server to the Nortel server subnetRequirements Installing the Nortel software feature dongleTo install the software feature dongle Connecting the server to power Before you beginTo connect the 1002rp AC server to power Plug the server AC power cord into the server rear panelTo connect the 1002rp DC server to power To start the server Copyright 2007, Nortel Networks Ferrites secured to an external cable Index Index Tlan Index Page 1002rp Server Hardware Installation