Transcend Information TS64GSSD25S-M, TS128GSSD25S-M, TS64GSSD25S-S, TS32GSSD25S-M TS192GSSD25S-M

Page 11

TS8GSSD25S-S
TS16GSSD25S-S/M
TS32GSSD25S-S/M
TS64GSSD25S-S/M
TS128GSSD25S-M	2.5” Solid State Disk
TS192GSSD25S-M	2.5” Solid State Disk

Figure 5 : comreset sequence

Description:

1.Host/device are powered and operating normally with some form of active communication.

2.Some condition in the host causes the host to issue COMRESET

3.Host releases COMRESET. Once the condition causing the COMRESET is released, the host releases the COMRESET signal and puts the bus in a quiescent condition.

4.Device issues COMINIT – When the device detects the release of COMRESET, it responds with a COMINIT. This is also the entry point if the device is late starting. The device may initiate communications at any time by issuing a COMINIT.

5.Host calibrates and issues a COMWAKE.

6.Device responds – The device detects the COMWAKE sequence on its RX pair and calibrates its transmitter (optional). Following calibration the device sends a six burst COMWAKE sequence and then sends a continuous stream of the ALIGN sequence starting at the device's highest supported speed. After ALIGNP Dwords have been sent

Transcend Information Inc.

11

V1.08

Image 11

Contents V1.08 Placement FeaturesDimensions DescriptionSpecifications Model P/N User Max. LBA Cylinder Head Sector Model P/N Sequential ReadMaxSequential WriteMax Compliance Data Reliability Data RetentionOperating Non-Operating Package Dimensions Pin No Pin Name Pin AssignmentsPin Layout Block Diagram Bad-block management ReliabilityWear-Leveling algorithm ECC algorithmSata Interface Out of bank signalingComreset TS192GSSD25S-M Cominit TS192GSSD25S-M Power on sequence Power on sequence timing diagramATA command register Command Name Code Command TableSET Features ATA Command Specifications Word Value Description Identify Device Information Default ValuePIO data transfer cycle timing mode Reserved TS192GSSD25S-M Minor version number TS192GSSD25S-M TS192GSSD25S-M Current AAM value 15-8 Vendor’s recommended AAM value 95-99 Read Buffer E4h Idle E3hIdle Immediate E1h Initialize Device Parameters 91hRead LOG EXT 2Fh Log Address Log Name Feature Set AccessRead DMA EXT 25h Read Fpdma Queued 60hRecalibrate 10h Security Disable Password F6hRead Verify Sectors 40h/41h Read Verify Sectors EXT 42hSecurity Unlock F2h Security set Password data contentSecurity SET Password F1h Features register Value and settable operating mode Smart Function Set B0h Code Smart SubcommandByte Description Byte 2-361 Individual attribute dataDescription Detail Information Byte Attribute ID information is listed in the following tableSmart Read Attribute Threshold Smart Enabl Operations Write DMA CAh Standby E2hStandby Immediate E0h Write Buffer E8hWrite Sectors EXT 34h Write Multiple EXT 39hWrite Multiple FUA EXT CEh Write Sectors 30h/31hTaiwan Germany Ordering Information