MGE UPS Systems 6 kVA Failure of AC input power and operation on battery power, Glossary Index

Page 5

		Contents
3.4 Failure of AC input power and operation on battery power		.................................................... 20
	Transfer to battery power	20
	Threshold for the low-battery shutdown warning	20
	End of backup time	20
	Sleep mode	20
	Return of AC input power	20
3.5	Personalization	21
	Function	21
	"ON / OFF conditions" tab	21
	"Battery" tab	22
	"Output" tab	22
	"By-pass" tab	22
3.6	Shutdown	23
	Shutdown of connected equipment	23
	Complete shutdown of the UPS	23

4.Maintenance

4.1	Troubleshooting	24
4.2	Replacement of the electronic module	26
	Disconnecting the connection module	26
	Reconnecting the connection module	27
5. Environment		28

6.Appendices

6.1	Glossary	29
6.2	Index	31

51033212EN/AC - Page 5

Image 5

Contents Comet EXtreme InstallationIntroduction Pictograms Using this documentForeword Contents Glossary Index Failure of AC input power and operation on battery powerComet EXtreme range Presentation6 kVA tower models 6 kVA rack models12 kVA tower models 12 kVA rack models Comet EXtreme 9 and 12 kVA BackComet EXtreme 4.5 and 6 kVA Battery extensions for UPS backup times of 80 minutes EPO Emergency Power OffBattery extensions for 4.5 or 6 kVA Comet EXtreme OptionsCLA Battery extensions for 9 or 12 kVA Comet EXtremeControl panel Alarms Battery Load RemainingUnpacking and checks InstallationElectronic module Battery module Electronic module Rack mounting diagram with rails Installation of the rack versionCheck that the battery circuit breaker 2 is OFF Battery-module connectionsConnection to the RS 232 communications port optional Installation of the communications-card optionConnection to the connection modules Always connect the earthing wire firstOperation ON-LINE operating modeBargraph indications When button 15 is pressedStart-up Failure of AC input power and operation on battery power Personalization Personalizable function Default settingFunction On / OFF conditions tabPersonalizable function Default setting Options Battery tabOutput tab By-pass tabShutdown Connected equipment is no longer supplied with powerTroubleshooting MaintenanceFrench Training Center on Montbonnot site USA Training Center on Costa Mesa siteMaintenance Disconnecting the connection module Replacement of the electronic moduleConnected equipment is again protected by the UPS Reconnecting the connection moduleEnvironment UPS recycling at the end of service lifeThis product has been designed to respect the environment PackingAppendices ON-LINE modeGlossary Manual bypassStart on battery power Sleep modeTolerance for AC-power Out of toleranceUPS Driver Index32 51033212EN/AC

Contents

3.4 Failure of AC input power and operation on battery power

4.Maintenance

Glossary

Index