MGE UPS Systems 6 kVA, 4.5 kVA, 9 kVA, 12 kVA Personalization, Function, On / OFF conditions tab

Page 21

3. Operation

3.5 Personalization

Function

Personalization parameters can be set and modified using the "UPS Driver" software installed on a computer that is connected to the UPS (see section 2.3 Connection to the RS 232 communications port).

Check that the RS 232 cable 22 is correctly connected and that the battery circuit breaker 2 is closed.

"UPS Driver" installation:

1 - Insert the Solution-PacCD-ROM containing the UPS Driver software in the drive of a PC running Windows.

2 - Open the Windows File manager or Explorer and select the CD-ROM drive.

3 - Double-click "\Emb\Index.htm", then "UPS Driver".

Once "UPS Driver" has been installed, UPS parameters can be modified in a window containing a number of tabs, each presenting a set of parameters.

"ON / OFF conditions" tab

Personalizable function	Default setting

Automatic start	Enabled

Cold start (battery power)	Enabled

Forced shutdown	Enabled

Sleep mode	Disabled

UPS ON / OFF via software	Enabled

51033212EN/AC - Page 21

Image 21

Contents Comet EXtreme InstallationIntroduction Using this document ForewordPictograms Contents Glossary Index Failure of AC input power and operation on battery powerComet EXtreme range Presentation6 kVA tower models 6 kVA rack models12 kVA tower models 12 kVA rack models Back Comet EXtreme 4.5 and 6 kVAComet EXtreme 9 and 12 kVA Battery extensions for UPS backup times of 80 minutes EPO Emergency Power OffBattery extensions for 4.5 or 6 kVA Comet EXtreme OptionsCLA Battery extensions for 9 or 12 kVA Comet EXtremeControl panel Alarms Battery Load RemainingInstallation Electronic module Battery moduleUnpacking and checks Electronic module Rack mounting diagram with rails Installation of the rack versionCheck that the battery circuit breaker 2 is OFF Battery-module connectionsConnection to the RS 232 communications port optional Installation of the communications-card optionConnection to the connection modules Always connect the earthing wire firstOperation ON-LINE operating modeWhen button 15 is pressed Start-upBargraph indications Failure of AC input power and operation on battery power Personalization Personalizable function Default settingFunction On / OFF conditions tabPersonalizable function Default setting Options Battery tabOutput tab By-pass tabShutdown Connected equipment is no longer supplied with powerTroubleshooting MaintenanceFrench Training Center on Montbonnot site USA Training Center on Costa Mesa siteMaintenance Disconnecting the connection module Replacement of the electronic moduleConnected equipment is again protected by the UPS Reconnecting the connection moduleEnvironment UPS recycling at the end of service lifeThis product has been designed to respect the environment PackingAppendices ON-LINE modeGlossary Manual bypassStart on battery power Sleep modeTolerance for AC-power Out of toleranceUPS Driver Index32 51033212EN/AC