MGE UPS Systems 9 kVA Out of tolerance, Percent load, Personalization, Sleep mode, Via software

Page 30

6. Appendices

Out of tolerance	The AC input source is either absent or its voltage or frequency is outside the
	set limits.
Percent load	Ratio between the power drawn by the connected equipment and the total
	power that the UPS can supply.
Personalization	A number of UPS functions can be modified using the "UPS Driver" software
	to better meet the user's needs.
Sleep mode	This function shuts down the UPS after 5 minutes when it operates on
	battery power and no load is detected on the UPS output. The UPS restarts
	automatically as soon as the AC input source is restored.
Start on battery power	This function makes it possible to energize the connected equipment even
	when AC input power is not available (operation exclusively on battery power).
Tolerance for AC-power	The range of frequency supplied by the AC-power source within which
source frequency	the UPS can operate in ON-LINE mode (double conversion).
UPS	Uninterruptible Power Supply.
UPS ON / OFF	It is possible to enable or disable use of UPS ON / OFF controls
via software	by the computer-system protection software.

Page 30 - 51033212EN/AC

Image 30

Contents Installation Comet EXtremeIntroduction Using this document ForewordPictograms Contents Failure of AC input power and operation on battery power Glossary Index6 kVA tower models PresentationComet EXtreme range 6 kVA rack models12 kVA tower models 12 kVA rack models Back Comet EXtreme 4.5 and 6 kVAComet EXtreme 9 and 12 kVA Battery extensions for 4.5 or 6 kVA Comet EXtreme EPO Emergency Power OffBattery extensions for UPS backup times of 80 minutes OptionsBattery extensions for 9 or 12 kVA Comet EXtreme CLAAlarms Battery Load Remaining Control panelInstallation Electronic module Battery moduleUnpacking and checks Electronic module Installation of the rack version Rack mounting diagram with railsBattery-module connections Check that the battery circuit breaker 2 is OFFInstallation of the communications-card option Connection to the RS 232 communications port optionalAlways connect the earthing wire first Connection to the connection modulesON-LINE operating mode OperationWhen button 15 is pressed Start-upBargraph indications Failure of AC input power and operation on battery power Function Personalizable function Default settingPersonalization On / OFF conditions tabOutput tab Battery tabPersonalizable function Default setting Options By-pass tabConnected equipment is no longer supplied with power ShutdownFrench Training Center on Montbonnot site MaintenanceTroubleshooting USA Training Center on Costa Mesa siteMaintenance Replacement of the electronic module Disconnecting the connection moduleReconnecting the connection module Connected equipment is again protected by the UPSThis product has been designed to respect the environment UPS recycling at the end of service lifeEnvironment PackingGlossary ON-LINE modeAppendices Manual bypassTolerance for AC-power Sleep modeStart on battery power Out of toleranceIndex UPS Driver32 51033212EN/AC