American Power Conversion AP9207 manual Ate cable. See Choosing simple signaling, Cables on

Connecting Share-UPScontinued

Connection	6 Connect the master server to port 1, the Advanced
procedure,	port of Share-UPS, using the smart-signaling cable
continued	(940-0024) supplied with your UPS. (See “Master
	server versus other servers” on page 11.)
	Note: A server not supported by PowerChute plus
	must use simple signaling with the appropri-
	ate cable. (See “Choosing simple signaling
	cables: Table 1” on page 4.)
	If an accessory, such as Measure-UPS II or
	an Expansion Chassis, is already using the
	(Advanced) Computer Interface port of the
	UPS, connect the master server to the UPS
	Monitoring port on the accessory. (Accesso-
	ries label this port in different ways, but the
	function — replicating the Computer Inter-
	face port of the UPS — is the same.)
	7 Connect the other server(s) to the Basic ports on
	Share-UPS, using APC cables. See “Choosing
	simple signaling cables: Table 1” on page 4.
	Note: Servers connected to the Basic ports of
	Share-UPS use simple signaling for moni-
	toring the UPS. If these servers use
	PowerChute plus, this software must be
	configured for simple signaling. See “Con-
	figuring PowerChute plus for simple
	signaling” on page 12.
After	After you have completed the connection procedure, con-
connecting	tinue with “Configuring Share-UPS” on page 23.
Share-UPS

22