American Power Conversion operation manual To the front of the Redundant Switch, connect

Page 14

Installation

Connect and route the cables

1.

To the front of the Redundant Switch, connect the

 

communications cable and any accessory cables that

 

require front connections.

2.

Route the cables around the Redundant Switch through

 

the side channel (marked with arrows below) to the

 

equipment in the rack.

 

Redundant Switch

3.

Optionally, install a plastic twist-lock (provided) on each

 

side to secure the cables.

10

APC Redundant Switch: Installation and Operation Manual

Image 14
Contents Redundant Switch APCThis manual is available in English on the enclosed CD Contents Page Before You Begin Pre-Installation Procedures Part Number Description QuantityAvailable Models Voltage Source Input Load OutputModel SU043 SU042-4Do not remove this device Model SU045-1Installation Following example shows how to attach the bracket for See Appendix a Rack-Mount Supplement Installation To the front of the Redundant Switch, connect Use two people to lift the Redundant Switch Turn on the equipment and Redundant Switch Configuration Both UPSs must be the same sine-wave modelRestart the computer on which PowerChute plus is Operation Function LED Display DescriptionYou can use a remotely operated Emergency Power Off EPO LED Display Status of Source Function Select LED Indicator. The three green FunctionFunction Status LED Indicator. The green Function Status Troubleshooting Problem Possible Cause Corrective ActionsContinuously for capability to carry a load and ability to Specifications SpecificationSU043 and SU044-1 SU045 Appendix a Rack-Mount Supplement Type of Rack Hole Type Hardware Required Express or implied, including warranties of merchantability Warranty and ServiceExcept as provided herein, APC makes no warranties Fitness for a particular purpose. Some jurisdictions doWarranty and Service Life-Support Policy Page Radio Frequency Interference APC Worldwide Customer Support USA