American Power Conversion 400 user manual 100, 120 Vac versions, 220/230/240 Vac version

Page 13

4.0 Installation

4.3Connect UPS to service and enable 4.3.1 Connect UPS to service

■100, 120 Vac versions

Plug the UPS into a two-pole, three-wire grounding receptacle only. Avoid the use of extension cords and adapter plugs.

■220/230/240 Vac version

The 220/230/240 Vac version UPS is not furnished with an input line cord. Instead, two output cords are supplied. However, in most installations you will not need to purchase a UPS input power cord. Simply swap the line cords from your equipment with the furnished output cords, and plug in the UPS using one of the equipment cords.

If your equipment does not have a removable line cord, the provided rewireable plug may be installed on the line cord. Additional output cords and adapter plugs are available from your dealer and from the factory.

The UPS may be configured to operate where 240 Vac, 50 Hz service is provided. When Option Switch 2 is set to the on (down) position, the UPS’s transfer and on-battery output voltages are adjusted for proper operation on 240 Vac service (see Sec. 5.4).

11

Image 13

Contents Smart-UPS Radio frequency interference Important safety instructionsTable of Contents Storing the UPS SpecificationsOverview IntroductionSmartBoost Battery replacement indicators and testRemote interfaces Extended capabilitiesEnglish SafetyFrançais SécuritéVorsicht Sicherheit¡Atencion ¡Seguridad400VA UPS-front panel Presentation400VA UPS-rear panel Placement InstallationReceiving inspection 220/230/240 Vac version 100, 120 Vac versionsAuto-on operation Charge the batteriesConfigure Option Switch 4 and UPS Enable switch Plug in the accessory devicesTurn on accessories Plug in the master deviceManual operation Enable the UPSPlug loads into UPS Operation Test button functions 5.2.1 Line Voltage bar graph UPS self-test Output Power bar graphOn-battery alarm Audible alarmsLow battery Replace batteryOption Switch Option switchesVac version No function not used Monitoring Status reportingPower management Operation customizing Minimum battery capacity to restart Audible alarm operationShut down, turn off delay Turn on delayUPS Monitoring PowerChute SoftwareInterface Kits Computer Interface port Difficulty Difficulté Schwierigkeit Dificultad Solution TroubleshootingPossible cause Troubleshooting UPS Battery replacement check Obtaining service Storage conditions Storing the UPSExtended storage Transfer characteristics SpecificationsOutput characteristics InputSurge and noise suppression Battery and charger UPS version VacOperating Environment Physical WeightApprovals Size H´W´DLoad Run Time Typical computer VA † minutes ‡ Equivalents Typical run times versus loadLife support policy Limited Warranty∗ Mailing