American Power Conversion 400 user manual Operation

Page 17

5.0Operation

5.1Front-panel indicators

	Replace Battery	Low Battery	Overload	On Battery	On Line
	indicator	indicator	indicator	indicator	indicator
	see Sec. 5.1.1	see Sec. 5.1.2	see Sec. 5.1.3	see Sec. 5.1.4	see Sec. 5.1.5

5.1.1 Replace Battery indicator

The Replace Battery indicator lights when the UPS’s battery fails the self-test. The indicator turns off after a successful self-test.

5.1.2 Low Battery indicator

The Low Battery indicator lights when less than 2 minutes of backup power are available from the battery.

5.1.3 Overload indicator

The Overload indicator lights when the load exceeds the UPS’s rating of 400 VA (250 W).

5.1.4 On Battery indicator

The On Battery indicator lights when the load has been transferred to UPS battery power, and the utility voltage is not within speci- fied limits.

5.1.5 On Line indicator

The On Line indicator lights when the load is being supplied conditioned power from the utility service. This indicator blinks during the self-test.

15

Image 17

Contents Smart-UPS Radio frequency interference Important safety instructionsTable of Contents Storing the UPS SpecificationsOverview IntroductionSmartBoost Battery replacement indicators and testRemote interfaces Extended capabilitiesEnglish SafetyFrançais SécuritéVorsicht Sicherheit¡Atencion ¡Seguridad400VA UPS-rear panel Presentation400VA UPS-front panel Receiving inspection InstallationPlacement 220/230/240 Vac version 100, 120 Vac versionsAuto-on operation Charge the batteriesConfigure Option Switch 4 and UPS Enable switch Plug in the accessory devicesTurn on accessories Plug in the master devicePlug loads into UPS Enable the UPSManual operation Operation Test button functions 5.2.1 Line Voltage bar graph UPS self-test Output Power bar graphOn-battery alarm Audible alarmsLow battery Replace batteryOption Switch Option switchesVac version No function not used Monitoring Status reportingPower management Operation customizing Minimum battery capacity to restart Audible alarm operationShut down, turn off delay Turn on delayInterface Kits PowerChute SoftwareUPS Monitoring Computer Interface port Difficulty Difficulté Schwierigkeit Dificultad Possible cause TroubleshootingSolution Troubleshooting UPS Battery replacement check Obtaining service Extended storage Storing the UPSStorage conditions Transfer characteristics SpecificationsOutput characteristics InputOperating Environment Battery and charger UPS version VacSurge and noise suppression Physical WeightApprovals Size H´W´DLoad Run Time Typical computer VA † minutes ‡ Equivalents Typical run times versus loadLife support policy Limited Warranty∗ Mailing