American Power Conversion 400 Battery and charger UPS version Vac, Surge and noise suppression

Page 40

9.0 Specifications

9.4 Battery and charger UPS version (Vac): 100

120

220/230/240

Battery type: Spill proof, maintenance free sealed lead-calcium.

Typical battery life:3 to 6 years.

Battery life dependent on number of discharges and ambient temperature.

Low battery signaling: Continuous visual and audible alarm 2 minutes before shutdown.

Recharge time: 5 hours typical from total discharge. UPS may be used immediately after discharge but will provide shorter backup time.

9.5 Surge and noise suppression

Surge energy rating (Joules, maximum):

160

320

320

One occurrence, 10/1000 µs waveform.

 

 

 

Surge current capability (maximum):

6500 Amp peak.

One occurrence, 8/20 µs waveform.

 

 

 

Surge response time: 0 ns (instantaneous) normal mode; less than 5 ns

common mode.

 

 

 

 

 

 

 

Surge voltage let-through:

<0.7%

<0.7%

<2.0%

per ANSI C62.41 Cat. A 6 kV test.

 

 

 

 

 

 

 

Noise filter range:

100 kHz to 10 MHz

Normal and common mode EMI/RFI suppression.

 

 

9.6 Operating Environment

Operating temperature:

0 to +40°C (+32 to +104°F)

 

 

Storage temperature:

–15 to +45°C (+5 to +113°F)

 

 

Operating & storage relative humidity:

0 to 95%, non-condensing

 

 

Operating elevation:

0 to 3,000 m (0 to 10,000 ft)

 

 

Storage elevation:

0 to 15,000 m (0 to 50,000 ft)

Electromagnetic immunity:

IEC 801-2 level IV, 801-3 level III, 801-4 level IV, 801-5 level III.

Audible noise:

<45 dBA at 1 m (3 ft)

38

Image 40
Contents Smart-UPS Important safety instructions Radio frequency interferenceTable of Contents Specifications Storing the UPSIntroduction OverviewBattery replacement indicators and test SmartBoostRemote interfaces Extended capabilitiesSafety EnglishSécurité FrançaisSicherheit Vorsicht¡Seguridad ¡Atencion400VA UPS-front panel Presentation400VA UPS-rear panel Placement InstallationReceiving inspection 100, 120 Vac versions 220/230/240 Vac versionCharge the batteries Auto-on operationPlug in the accessory devices Configure Option Switch 4 and UPS Enable switchTurn on accessories Plug in the master deviceManual operation Enable the UPSPlug loads into UPS Operation Test button functions 5.2.1 Line Voltage bar graph Output Power bar graph UPS self-testAudible alarms On-battery alarmLow battery Replace batteryOption switches Option SwitchVac version No function not used Status reporting MonitoringPower management Operation customizing Audible alarm operation Minimum battery capacity to restartShut down, turn off delay Turn on delayUPS Monitoring PowerChute SoftwareInterface Kits Computer Interface port Difficulty Difficulté Schwierigkeit Dificultad Solution TroubleshootingPossible cause Troubleshooting UPS Battery replacement check Obtaining service Storage conditions Storing the UPSExtended storage Specifications Transfer characteristicsOutput characteristics InputSurge and noise suppression Battery and charger UPS version VacOperating Environment Weight PhysicalApprovals Size H´W´DTypical run times versus load Load Run Time Typical computer VA † minutes ‡ EquivalentsLimited Warranty Life support policy∗ Mailing