American Power Conversion 400 user manual Difficulty

Page 29

7.0 Difficulty

ENGLISH

Caution!

CAUTION!

■This Uninterruptible Power Source contains potentially hazardous voltages. Do not attempt to disassemble the unit. The unit contains no user serviceable parts. Repairs are performed only by factory trained service personnel.

■This Uninterruptible Power Source uses batteries. The batteries will eventually become too weak to provide rated autonomous operation. Due to the potential health and environmental hazards posed by the batteries, they may be replaced only at factory authorized Service Centers. To obtain battery replacement or repair service, please call the Customer Service telephone number written on the cover of this manual for information on the Service Center nearest you.

■The batteries used by this Uninterruptible Power Source are recyclable. Proper disposal of the batteries is required. The batteries contain lead and pose a hazard to the environment and human health if not disposed of properly. Please refer to local codes for proper disposal requirements or return the unit to a factory authorized Service Center for battery replacement or disposal.

■Battery replacement should be performed or supervised by personnel familiar with the danger of batteries and the required precautions. Keep unauthorized personnel away from batteries. When replacing batteries, use the same number and type of sealed lead acid batteries as were originally contained in your UPS.

■CAUTION—Do not dispose of batteries in a fire. The batteries may explode.

■CAUTION—Do not open or mutilate batteries. They contain an electrolyte which is toxic and harmful to the skin and eyes.

■CAUTION—A battery can present a risk of electrical shock and high short circuit current. When replacing batteries, wrist watches and jewelry such as rings should be removed. Use tools with insulated handles.

27

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Smart-UPS Radio frequency interference Important safety instructionsTable of Contents Storing the UPS SpecificationsOverview IntroductionSmartBoost Battery replacement indicators and testRemote interfaces Extended capabilitiesEnglish SafetyFrançais SécuritéVorsicht Sicherheit¡Atencion ¡Seguridad400VA UPS-rear panel Presentation400VA UPS-front panel Receiving inspection InstallationPlacement 220/230/240 Vac version 100, 120 Vac versionsAuto-on operation Charge the batteriesConfigure Option Switch 4 and UPS Enable switch Plug in the accessory devicesTurn on accessories Plug in the master devicePlug loads into UPS Enable the UPSManual operation Operation Test button functions 5.2.1 Line Voltage bar graph UPS self-test Output Power bar graphOn-battery alarm Audible alarmsLow battery Replace batteryOption Switch Option switchesVac version No function not used Monitoring Status reportingPower management Operation customizing Minimum battery capacity to restart Audible alarm operationShut down, turn off delay Turn on delayInterface Kits PowerChute SoftwareUPS Monitoring Computer Interface port Difficulty Difficulté Schwierigkeit Dificultad Possible cause TroubleshootingSolution Troubleshooting UPS Battery replacement check Obtaining service Extended storage Storing the UPSStorage conditions Transfer characteristics SpecificationsOutput characteristics InputOperating Environment Battery and charger UPS version VacSurge and noise suppression Physical WeightApprovals Size H´W´DLoad Run Time Typical computer VA † minutes ‡ Equivalents Typical run times versus loadLife support policy Limited Warranty∗ Mailing
Top Page Image Contents