APC 600 user manual 100, 120 Vac versions, 220/230/240 Vac version

Page 14

4.0 Installation

4.3Connect UPS to service and enable 4.3.1 Connect UPS to service

100, 120 Vac versions

Plug the UPS into a two-pole, three-wire grounding receptacle only. Avoid the use of extension cords and adapter plugs.

220/230/240 Vac version

The 220/230/240 Vac version UPS is not furnished with an input line cord. Instead, two output cords are supplied. However, in most installations you will not need to purchase a UPS input power cord. Simply swap the line cords from your equipment with the furnished output cords, and plug in the UPS using one of the equipment cords. The UPS’s input cord must be three conductor, each 1.0 mm2, rated to 10 Amps. ￿￿￿

If your equipment does not have a removable line cord, the provided rewireable plug may be installed on the line cord. Additional output cords and adapter plugs are available from your dealer and from the factory.

The UPS may be configured to operate where 240 Vac, 50 Hz service is provided. When Option Switch 2 is set to the on position, the UPS’s trans- fer and on-battery output voltages are adjusted for proper operation on 240 Vac service (see Sec. 5.5).

12

Image 14
Contents Smart-UPS Important safety instructions Radio frequency interferenceTable of Contents Specifications Storing the UPSIntroduction OverviewRemote interfaces Battery replacement indicators and testSmartBoost Extended capabilitiesSafety EnglishSécurité FrançaisSicherheit Vorsicht¡Seguridad ¡AtencionPresentation 600VA UPS-100 and 120 Vac versions600VA UPS-220/230/240 Vac version Receiving inspection InstallationPlacement 100, 120 Vac versions 220/230/240 Vac versionEnable UPS Plug loads into UPSSwitch on load equipment Switch on the UPSOperation Alarm disable button Power on buttonPower standby button Test buttonOutput Power bar graph Line Voltage bar graphLow battery Audible alarmsOn-battery alarm Replace batteryOption switches Option SwitchVac version No function not used Status reporting MonitoringPower management Operation customizing Shut down, turn off delay Audible alarm operationMinimum battery capacity to restart Turn on delayInterface Kits PowerChute SoftwareUPS Monitoring Computer interface port Difficulty Difficulté Schwierigkeit Dificultad Possible cause TroubleshootingSolution Troubleshooting Battery replacement check Obtaining service Extended storage Storing the UPSStorage conditions Output characteristics SpecificationsTransfer characteristics InputOperating Environment Battery and charger UPS version VacSurge and noise suppression Approvals WeightPhysical Size H´W´DTypical run times versus load Load Run Time Typical computer VA † Minutes ‡ EquivalentsPage Limited Warranty Life support policy∗ Mailing
Related manuals
Manual 48 pages 19.37 Kb