APC 600 user manual Audible alarms, On-battery alarm, Low battery, Replace battery, Overload

Page 20

5.0 Operation

5.4 Audible alarms

The UPS features an audible alarm that beeps to indicate certain conditions (see Secs. 5.4.1–5.4.4).

5.4.1 On-battery alarm

The UPS emits four short beeps every 30 seconds when the UPS is operat- ing on battery power. You may silence this alarm by pressing the alarm disable button (see Sec. 5.1.9). The on-battery alarm is reset when on-line operation is resumed.

5.4.2 Low battery

The UPS beeps steadily to indicate that less than 2 minutes of power remains before shutdown from battery exhaustion (or 5 minutes; see Sec. 5.5.4).

5.4.3 Replace battery

The UPS emits short beeps for 1 minute if the UPS’s batteries fail the self- test. If the UPS is left operating in this condition, the UPS emits short beeps once every 5 hours until a successful battery test is completed.

5.4.4 Overload

The UPS emits a loud, sustained tone when overloaded. When the load exceeds the UPS’s rating during on-line operation, the alarm sounds until the overload is removed. If the overload occurs during on-battery opera- tion, the alarm sounds until the UPS Enable switch on the rear panel is turned off.

18

Image 20
Contents Smart-UPS Important safety instructions Radio frequency interferenceTable of Contents Specifications Storing the UPSIntroduction OverviewBattery replacement indicators and test SmartBoostRemote interfaces Extended capabilitiesSafety EnglishSécurité FrançaisSicherheit Vorsicht¡Seguridad ¡AtencionPresentation 600VA UPS-100 and 120 Vac versions600VA UPS-220/230/240 Vac version Receiving inspection InstallationPlacement 100, 120 Vac versions 220/230/240 Vac versionEnable UPS Plug loads into UPSSwitch on load equipment Switch on the UPSOperation Power on button Power standby buttonAlarm disable button Test buttonOutput Power bar graph Line Voltage bar graphAudible alarms On-battery alarmLow battery Replace batteryOption switches Option SwitchVac version No function not used Status reporting MonitoringPower management Operation customizing Audible alarm operation Minimum battery capacity to restartShut down, turn off delay Turn on delayInterface Kits PowerChute SoftwareUPS Monitoring Computer interface port Difficulty Difficulté Schwierigkeit Dificultad Possible cause TroubleshootingSolution Troubleshooting Battery replacement check Obtaining service Extended storage Storing the UPSStorage conditions Specifications Transfer characteristicsOutput characteristics InputOperating Environment Battery and charger UPS version VacSurge and noise suppression Weight PhysicalApprovals Size H´W´DTypical run times versus load Load Run Time Typical computer VA † Minutes ‡ EquivalentsPage Limited Warranty Life support policy∗ Mailing
Related manuals
Manual 48 pages 19.37 Kb